Honda Spree and Elite 50 Forums

I'd say rebuilding the top end should fix it.

pull the exhaust off and look into the exhaust port. look at the piston walls, maybe you melted the rings to the piston? I've done this three times so far, but i have a 1/2 * motor built. =)

alright i'm going to rebuild the engine. 88-89 Honda Elite with a 98 engine in it. "Honda Dio"

PM'd what size?

i think so. guys this has been years since i've even thought about rebuilding the bike again until I found this forum. =) So being that I bought it on ebay, probably leaves me to think it was a cheap tawain jug. I'm picking up the bike today when i get off work. I'll pull the jug and take pictures. ...

I guess I should have included that i have eliminated the stock oil pump, and went with a premix. I'm not sure what it was but that's not relevant at this time. I'm going to look into stroker crank and rod, with a big bore. Then go back to square one. I'm really excited there is a forum finally supp...

Keep nuking engines, why? What would cause two 'Big Bore' jug kits to fail in the same way? First run with the 70cc 'Big Bore Jug Kit' was pretty much all stock parts including the stock carb. After test driving the piston seized into the cylinder walls. My first thought that it was because of the s...

Nice to see after all these years that I've had my Honda elite 50cc in storage, that more sites have come out in the main stream. My question is that lately the Honda Ruckus are all the new rave with people now, and the Ruckus folks have been doing the gy6 150cc swaps for sometime. I'd like to know ...