Honda Spree and Elite 50 Forums

Petcock is working good. No intake leaks that I can tell.

I guess I will do the campfire exhaust burn.

I'm not a newbie but I need advice. The carb is clean (6 times over). I have seen the pin * of light. All of the holes are clear. New air filter. Here is the symptoms - it will stumble start but won't idle. If I hand choke the carb inlet it will fire up, rev up and with some dexterity I can get it t...

This is as close as you could get I reckon.

viewtopic.php?f=16&t=18513

Sold him the motor myself.

I bought this one on HF last year for 149 or so on sale. (coupons of course).

It doesn't have ball bearing drawers but it's held up well and does it's job.

http://www.harborfreight.com/hand-tools ... 67421.html

Get the photobucket APP.

I upload to photobucket straight from my iphone.

It's a little cumbersome to get the links and then cut/paste into the forum (from the iphone) but it's doable if you're patient.

I have 2010 Honda Elite 110. It has almost 3000 miles on it and it runs like a champ. I'm just looking to see if there are any ways to increase the speed either by air filter, exhaust or CDI. Has anyone tried, and I know I'm probably going to hear that I just need to get a bigger scooter if I want ...

tuserv wrote:aftermarket gasket set eBay chopchop*123

http://www.ebay.com/itm/Honda-Spree-NQ5 ... 03&vxp=mtr

Wow. Nice to know. Just confirming chopchop (ebay) and tazland (here) are the same person right?

They are no longer available. I'm guessing most people run without or they use a gasket liquid and hope for the best.

tazland001 wrote:You have a link to where to buy one?

Taz

Here's the closest one I could find....

http://www.drowsports.com/product/147/A ... us___Zuma_

yes mine looks exactly like yours !! splinez r ok!! could i purchase the new thrust washer from u ?? Um no but you could order it from your local honda dealer. cheapcycleparts (google it) has a parts microfiche and you can order from them. But I prefer to get the honda part no. and then call the de...

Don't let 666 see that.

Thanks for the compliments.

Where were you guys when I was seeking help on my build thread?

viewtopic.php?f=16&t=24576

why yes ! thatz it but this one not as bad!! very close any suggestions?? You need a new thrust washer. Yours (like mine) got loose enough to cause friction and wore out the middle section only to have it "let go" and end up around the shaft. Here's a pic of a new thrust washer and what I...

well got the dive face off and !after inspection found that some one has been here before theirs a little homemade washer on crank and u can tell where drive face must of came loose at one time because of ware markes on case,the back side of drive face also shows sighn of woble!! will a used drive ...

I'm pretty sure we're going to need some updated pics with Angie on the NS50.

Wink wink