Honda Spree and Elite 50 Forums

Hi, i am planning to gy6 swap my honda elite sb50p (dont hate pls) and i was wondering if i will have to change my rear wheel. I am planning to get a short case gy6 and reweld mounts on my honda scooter to accommodate the 150cc beast.

my motor was running really good for 3 minutes, and then it ran like crap. so i unplugged the bystarter and it runs good now continously. im not sure if i put the bystarter back correctly when i put it back on the carb because the little clip that has 2 screws bends allitle when i tighten the bystar...

my mpoed will run perfectly for about 5 minutes and then it would just run like crap. it will then start very easily but will bog down or have really low top speed (like 7 mph). i left it sitting about a year ago and it wouldnt even start. but after i cleaned the carb out, it started and ran perfect...

did your oil pump work? maybe you ran it without oil getting to the engine. that would cause it to overheat, and then break

You have an intake leak at the spacer between the carb and the manifold. Repair the threads on the rear bolt and replace the 2 orings on the spacer and carb. how do i repair the threads on those? it feels like they are holding pretty tight, and the o rings are still very rubbery, they dont feel lik...

ok, it has a brand new coil, sparkplug, and fresh gas (somewhat new oil). 6months ago, it ran and idled perfectly. after not starting it for a while, it didnt want to even start at all without ether. so i cleaned the carb and found the main jet was clogged. i put it back together and it started easi...

stucinthe80z wrote:yes i would do this and also clean youre carb if not done but it sounds like the throtel cable was put in 180 degrees off very easy to do there is a slide slot cut into the base good luck

what do you mean by the the throttle cable being 180 degrees off? and where is the slide slot?

i have an elite sb50p 1989 and it wont stay running. about 6 months ago, it started and ran fine with no problems. after not starting it for a long time, it wont start anymore. i replaced the sparkplug with a brand new one and it started on first kick. then it idled for about 5 seconds (very high id...

my moped used to start and run perfectly. but after a year of not riding/ starting it, it wont start anymore. i tried taking it apart and i put it back together and i got it to start (kickstart) but it runs at very low rpm and when i give it slight amount of throttle, it dies. also, when i put it ba...

my moped used to start and run perfectly. but after a year of not riding/ starting it, it wont start anymore. i tried taking it apart and i put it back together and i got it to start (kickstart) but it runs at very low rpm and when i give it slight amount of throttle, it dies. als, when i put it bac...

evilone wrote:Fill the oil container, the oil level sensor lights up when it senses no or low oil not when level is where it should be. Not sure about the clicking, sounds like something catching.

so i just fill oil to the top?

everything works extrmeley well. it idles insanely quiet and starts extremely easy with electric and kick start. however, everytime i turn, it makes a click everytime you turn past the halfway mark. it kinda get anoyying so i tryed removeing the 3 nuts on the front cover but the cover wont come off....