Search found 13 matches
- Sun Sep 15, 2013 2:49 am
- Forum: Technical Help
- Topic: Will my stock honda elite wheel work in a gy6?
- Replies: 1
- Views: 1390
Will my stock honda elite wheel work in a gy6?
Hi, i am planning to gy6 swap my honda elite sb50p (dont hate pls) and i was wondering if i will have to change my rear wheel. I am planning to get a short case gy6 and reweld mounts on my honda scooter to accommodate the 150cc beast.
- Fri Mar 01, 2013 9:36 pm
- Forum: Technical Help
- Topic: is my bystarter in correctly?
- Replies: 3
- Views: 2937
is my bystarter in correctly?
my motor was running really good for 3 minutes, and then it ran like crap. so i unplugged the bystarter and it runs good now continously. im not sure if i put the bystarter back correctly when i put it back on the carb because the little clip that has 2 screws bends allitle when i tighten the bystar...
- Thu Feb 28, 2013 9:21 pm
- Forum: Technical Help
- Topic: does the elite sb50p and sa50 use the same carb?-
- Replies: 4
- Views: 2365
does the elite sb50p and sa50 use the same carb?-
my mpoed will run perfectly for about 5 minutes and then it would just run like crap. it will then start very easily but will bog down or have really low top speed (like 7 mph). i left it sitting about a year ago and it wouldnt even start. but after i cleaned the carb out, it started and ran perfect...
- Thu Oct 25, 2012 6:36 pm
- Forum: Technical Help
- Topic: Honda spree engine destroyed.
- Replies: 6
- Views: 2982
Re: Honda spree engine destroyed.
did your oil pump work? maybe you ran it without oil getting to the engine. that would cause it to overheat, and then break
- Wed Oct 24, 2012 12:16 pm
- Forum: Technical Help
- Topic: honda elite sb50p doesnt idle/run right
- Replies: 7
- Views: 3181
Re: honda elite sb50p doesnt idle/run right
You have an intake leak at the spacer between the carb and the manifold. Repair the threads on the rear bolt and replace the 2 orings on the spacer and carb. how do i repair the threads on those? it feels like they are holding pretty tight, and the o rings are still very rubbery, they dont feel lik...
- Tue Oct 23, 2012 9:27 pm
- Forum: Technical Help
- Topic: honda elite sb50p doesnt idle/run right
- Replies: 7
- Views: 3181
- Tue Oct 23, 2012 7:25 pm
- Forum: Technical Help
- Topic: honda elite sb50p doesnt idle/run right
- Replies: 7
- Views: 3181
honda elite sb50p doesnt idle/run right
ok, it has a brand new coil, sparkplug, and fresh gas (somewhat new oil). 6months ago, it ran and idled perfectly. after not starting it for a while, it didnt want to even start at all without ether. so i cleaned the carb and found the main jet was clogged. i put it back together and it started easi...
- Sat Oct 20, 2012 10:39 pm
- Forum: Technical Help
- Topic: my elite starts, idles high, then dies
- Replies: 5
- Views: 3660
Re: my elite starts, idles high, then dies
what do you mean by the the throttle cable being 180 degrees off? and where is the slide slot?stucinthe80z wrote:yes i would do this and also clean youre carb if not done but it sounds like the throtel cable was put in 180 degrees off very easy to do there is a slide slot cut into the base good luck
- Sat Oct 20, 2012 8:30 pm
- Forum: Technical Help
- Topic: my elite starts, idles high, then dies
- Replies: 5
- Views: 3660
my elite starts, idles high, then dies
i have an elite sb50p 1989 and it wont stay running. about 6 months ago, it started and ran fine with no problems. after not starting it for a long time, it wont start anymore. i replaced the sparkplug with a brand new one and it started on first kick. then it idled for about 5 seconds (very high id...
- Sun Oct 14, 2012 3:27 pm
- Forum: Technical Help
- Topic: nooby here needs some help getting elite 50 to run
- Replies: 0
- Views: 1307
nooby here needs some help getting elite 50 to run
my moped used to start and run perfectly. but after a year of not riding/ starting it, it wont start anymore. i tried taking it apart and i put it back together and i got it to start (kickstart) but it runs at very low rpm and when i give it slight amount of throttle, it dies. also, when i put it ba...
- Sun Oct 14, 2012 3:26 pm
- Forum: Technical Help
- Topic: nooby here needs some help getting elite 50 to run
- Replies: 5
- Views: 3462
nooby here needs some help getting elite 50 to run
my moped used to start and run perfectly. but after a year of not riding/ starting it, it wont start anymore. i tried taking it apart and i put it back together and i got it to start (kickstart) but it runs at very low rpm and when i give it slight amount of throttle, it dies. als, when i put it bac...
- Fri Dec 24, 2010 2:51 pm
- Forum: General Discussion
- Topic: just got a honda elite 50 1989 off craigslist...
- Replies: 8
- Views: 3165
Re: just got a honda elite 50 1989 off craigslist...
so i just fill oil to the top?evilone wrote:Fill the oil container, the oil level sensor lights up when it senses no or low oil not when level is where it should be. Not sure about the clicking, sounds like something catching.
- Fri Dec 24, 2010 2:27 pm
- Forum: General Discussion
- Topic: just got a honda elite 50 1989 off craigslist...
- Replies: 8
- Views: 3165
just got a honda elite 50 1989 off craigslist...
everything works extrmeley well. it idles insanely quiet and starts extremely easy with electric and kick start. however, everytime i turn, it makes a click everytime you turn past the halfway mark. it kinda get anoyying so i tryed removeing the 3 nuts on the front cover but the cover wont come off....