Honda Spree and Elite 50 Forums

too bad i might have trashed mine!

I went with some math I read on here for running premix and pump. I didn't think to run 32:1 pre mix as well..... Shoot. Is that what most people do?

My ride last night was only about 4 miles. Not wot either. I haven't taken the cyl off since it started sputtering. I will probably do it Monday. And yes I could feel scoring with my fingernails. I've been going very easy on my scooter. But I've had so many setbacks. I might just trash the whole pos

Maddog look at the link I posted derp

Hey all I was riding my scooter tonight. Still breaking it in with a polini kit. Have about 30 miles. It started popping and sputtering no power but idles well for the most part. I'm afraid to start it. Specs are. 90main 47mm polini stock box and exhaust. Running pump and 65:1 in the tank. Had the c...

Maybe al the sliders aren't working. I cleaned the ramp plate as best I could with brake cleaner

No porting. Picture of the plug is in my build thread. Running 2k springs 1k center spring and new polini belt. Could the crank be off balance with the new piston. Running 90 main

Thanks!

more

more

apparently these are in no order. sorry guys

traded my spree for 2, basically garbage bikes. one was running with a 46mm kit. basically this was a tear down, clean, and tune up with the kit being cracked and needed to be replaced. finding a way to repair the cracked plastics proved difficult and eventually i repaired them and instead or painti...

if youre just looking for more power up hills i would try a stronger center spring, very cheap and easy

id also make sure you have the whole broken ring accounted for before you try to run it just in case is fell to the crank

i just bought a kit shipped for under 100. its 47mm comes with everything for the top end except you use the stock head. bumps its up to 65cc. and for about the same or less or a little more than you would pay for new oem parts. it is polini not a cheaply made kit.http://www.hondaspree.net/phpBB3/vi...