Honda Spree and Elite 50 Forums

I like all your nice p and p work keep it up. How much faster will this make you go?

If yourrunning a mini strokeim assuming the crank is newer with low miles

Maybe it only ran beacause you had air leaking in from your exhaust port

Does stacking base gaskets have anything to do with the exhaust flange not fitting properly? Your plug shouldn't be white with those huge jets and I'm surprised your bike even ran at all

If your jetting skills aren't up to par then don't waste money on a expensive bore. Get another ruima and get the jetting right. If your doing your plug chops right then the wwhite plug should have been a red flag telling you somethings not right. You need to start with the needle in the mid and mov...

Cheap and fast is not reliable and reliable and fast is not cheap

Very nice bike bro I wish my plastics looked nice like yours. Where did the side skirts go those are a must. Those scorpion pipes are almost as common as v8 pipes over here. I sold mine cause the v8 is better for wheelies

Roll iit off a cliff and save up for a dio

My malossi cast iron is the way to go unless you plan on using the mhr for race. Aluminum bores suck that's why vt doesn't sell them anymore

Eh oahu boy I thought you guys new how for wrench on bikes. Mabey you should come kona so we can school you on it

There is also a small tube with a flanged end where the carb bolts to the intake mani. It restricts air and gas going to reeds.

Are you on drugs

Dude those are some old saggy boobies. Get a hotter drunk chick to model your floor board haha

Buy a aftermarket cooling fan. Vt cycles sells them. It won't help a lot but it helps somewhat. Up your jets a size or two and start with the clip in the middle and move it down one notch at time. Zip around only using the pilot jet and see what your temps are going quarter and half throttle. Zip ar...

Try 8.44:1 gears and run 8 and 9 gram weights