Honda Spree and Elite 50 Forums

The motor looks different to an NQ50 motor. the number starts AF05E

Many thanks kind sir!
I shall dig out the numbers for you in the near future, and a PM ye shall receive.
It's much preferable to have it rego'd by it's 50 code than by model name. (Especially if I ever need to play muscial number plates again!)

Hey, I have a honda eve PAX 50cc scooter. I've been riding it around for almost a year using the number plate and rego off my nq50. I had a wee brush with the law a few weeks back, where he tried to tell me my scooter needed a WOF. (Warrant of fitness) And I told him that (In New Zealand) bikes unde...

Me doing a burnout on my honda. I crashed into the house partway through because I was pretty drunk at the time.

Enjoy; http://www.youtube.com/watch?v=IZpMbRAROJw

What do you mean? :lol: Actually my father in law is an unholsterer. He did a really nice job of my NQ50. So it's on the cards to get it done. I found the side covers for it yesterday too. So at some point it'll be getting a respray too. It actually only done about 1000 miles from new. It bought int...

My friend short this wee vid of me on my honda. The tyre is almost new, so I didn't get too carried away. But I thought some of you might like it.

http://vimeo.com/4940829

I rang these people this morning. WOuld you believe, they refuse to sell to people who are outside the US? FFS, I've ven got a shipping address in the US. But they don't want to know. They don't even trade on mondays. (due to the ressecion I assume) But they wont sell me parts. Man it sux! I'm going...

so that 903 number is their non toll free number? awsome thanks. I can't ring thier toll free number from here.

I'm planning to buy some parts to freshen up a couple of Nq50 motors off a US based honda parts company. They have a website, (which I prefer not to use) and a toll free number. Being off shore, I can't call that. Can one of you kind fellows please ring 8667671835 (toll free) and ask them if they ha...

what about removing material from the top of the jug?

would it be a smart move to machine material from the bottom of the jug where it bolts up to the crankcase, to raise the deck height of the piston and increase compression? Or is there some pitfall in doing this?

excellent!

bradthreee wrote:One is for regular size piston, another for .025 over size piston, and another for .50 over size piston

if you have a closer look, it lists more than one number for the same size ring. The OS rings are listed below.
So I'll be all good if I just order the part which superceeds the old one?

I'm getting set to order some parts online to freshen up a couple of NQ50 engines that I have. BUT, if you look at the parts listing for the rings, http://www.hondaparts-direct.com/fiche_section_detail.asp?section=152966&category=Scooters&make=Honda&year=1986&fveh=3555 it shows two d...

thanks guys. I've done the porting on my intake. But I'm currently on the scrounge for an SB50 intake and reid valve for it.