Honda Spree and Elite 50 Forums

Hi everyone! I was wondering what's the best break procedure? I was thinking 8-10 heat cycles. Then 400 miles staying under half throttle and not going over 30mph. What do u guys think? I havent found much info on the topic.

Thanks for the help. now i have a good place to start.

Is there a break in for clutches?

I ordered a bunch of stuff for my moped, and i was wondering if anyone can give me some good advice on where to start. I have an 89 Elite E sb50p that i swapped a af16e into. Right now it has a 2g polini clutch, Kelli Variator with 6g rollers, 9 to 1 gears, and a oil pump plug. I ordered a 72cc MHR ...

Thanks guys for all the info! Ill have to use a gps when it gets warm enough to start riding. Not trying to make anything up. Can someone show me a link to a stronger clutch. And will i need a different clutch bell. Ill check my gear ratio soon :thumbwink: How much slower will takeoff be with 9:1 ge...

Hey everyone! I am looking for primary gears for my motor. I have an af16e from a SA50 "S" but has been derestricted to basiacally being an "SR" so far i can reach around 50mph. With a variator, rollers, oil plug and yellow contra. But i would like to get gears for it so i have a...

So i figured 8g weights work the best for me. Ive been looking into getting new final gears now, im curious about ratios. I would like it to be faster off of the line. What would u guys suggest looking into? Where is the best place to buy them? Do i need any other parts to make them work? I plan on ...

So i lightened the weights once, and it improve a little bit, but it got too late so i had to stop for the night, i put in three 7 and three 8g(stagered of course :wink: ) and ill start with those tomorrow. But it seems like acceleration was a little sluggish off the line and at about 10mph it would...

So i got everyting together and running, but its very slow acceleration, go lighter?

K ill do that too... So can anyone answer my ? About the direction of the rollers?

Any opinions on which way the rollers go in?

that's what i did

well, once i get the old variator off, ill put on the new one and ill see what happens, im going to start with three 7g and three 10g rollers... this is probably a newb question, but does it matter which way the rollers go in the variator? my guess is the side that covers up the metal inside the rol...

Ok, well i have a 2k contra and 2k shoe springs now so should i lower the weight?

anyone have ideas on what weights to start with? i just got my keli variator today

Ok, ill buy a plug, whats a good ratio?