Honda Spree and Elite 50 Forums

anyone in or near Lansing mi that works on scoots ?

so jelly i wish my scoot was done

nice cant wait to see more

ok i'm down to the final shaft bearing is bad lol and hitting it out don't seem to be getting me anywhere is there anything i need to know about removing this shaft i have been looking threw the forums looking don't seem to be finding what im looking for

ok i have never taken a rear end apart on one of these motors wish me luck lol

brakes were locked i have knocked them free the wheel spins free im pretty sure the splines on the saft have rusted right to the rim ....wheel man so let me get the straight i can take the trans cover off and knock the spline out ?

the nut and washer are off its just rust holding the shaft on the rim i have tried heat and pb nothing is working

lol i have a rim that is stuck to the shaft bolt is off * i even tried a pulley puller no luck lol

hi i have a af16e the rim is stuck to the shaft i have tried all the basics to get it off any advice would be greatly appreciated

i got all three of my scoots for under 100$ i've spent close to 3 grand building them lol. personally i'm done with the spree mods only stock ones from now on out. i would rather work on a ellite myself but then again its all about what u like .

I have been looking for a few things lathe mill etc nice pick up man i hope u start turning out some cool one offs for us to check out !

if its got two wheels i like it even the ugly bikes * i like them more ..no one wants them they are cheap

look him up on ebay his name is chopchop

might want to take a look around there are lots of posts on this topic ..as lots of members have said to me reading is good bro

theses are your options...you can buy the taz bbk or u can do a motor swap...there's not much out there for the spree motor