Honda Spree and Elite 50 Forums

I believe the rings just broke and pieces scratched the cylinder and piston.

I was riding my 86 honda spree and i heard a clicking sound in the engine and then it died. my friend took it apart and said that something in the engine broke scratching the cylinder and piston. i want to know how this would happen. did it overheat? if i fix it how can i ensure it will not happen a...

Bulbs are all fine. Could it be a loose wire?

check compression. bad compression will keep it from starting. its usually the carb though. use carb cleaner and shoot it through all the jets.

so i just fixed my honda spree scooter. replaced the piston rings. it starts just fine, but the head light and dash light will not turn on. all the other lights turn on with the battery connected, but without the battery no lights work. does anyone know why my head light and dash lights do not work....

The elite hasn't been started in a long time. Will the elite jug and piston fit the spree? And where can I get the necessary gaskets? Will it normally start if the jug is done? After we dropped the oil in the cylinder it was running great for hours. Thanks again for the help.

So my spree wasn't running and I thought it was the carb. My buddy came by and threw some oil in the cylinder head. The 1986 spree fired right up. I'm guessing its the rings that are done right? I just need to know what else it could be. I have a 1988 elite I can take parts from. What parts should i...

Yeah it is in place and it has a filter. Ive cleaned the carb about 8 times

It has about 115.

So that problem is fixed. Good compression it has a good spark and I just cleaned the carburetor. Still will not start. The carb is getting gas I'm all out of ideas. What can it be?

So I cleaned my carb on my 1986 spree and I don't know where the ports are supposed to face on the emulsion tube. Anyone know where I can find this information.

Ok thank you. But the stock bolts will not reach. I have to go to the hardware store and buy some. I just don't know the specs. How thick are they?

So I took my carb off to clean it and unfortunately stripped it. Now it's loose and will not seal properly. And my spree will not start. This could be a cause for it not starting right?? I want to go the route of attaching two nuts to the backside. I just need to know what size bolts to buy. And wha...

So my spree was turning on fine but it would not idle. i took the carb off cleaned it and it ran like a champ... for a day. the next morning it would not start. i took it apart again and the only thing i noticed was that the bystarter needle was hanging extra low. i believe if its cold it should be ...

a thin wire attached to positive end of the battery on my 86 honda spree burnt today. now my electric starter wont work. any one know how to replace it? and is it included in the wire harness. or can i use any ordinary cable?