Honda Spree and Elite 50 Forums

I already have taller gears. Would doing the zx trans kill all my torque or does the different angle for better acceleration make up for that?

So I have an elite sr and the rear variator is pretty pitted from rust and it's chewing/sanding down my belts. Can you get aftermarket pulleys? I know there's a drive face and I have a new variator but do I just have to source out a used rear pulley now or is there something available?

I'll keep going down inwith the main and see where it leads. I think the smallest I have at the moment is a 170. I was planning on trying the 190 today anyways. Ill put it in and drive a few miles since its a new cylinder then go lower again. I figured it was pretty rich with the needle having to be...

I've got about 10 years in of experience with mopeds. So I've got the general idea down for sure. I do have a temp gauge. So far head temps are around 300-320 with a 200 main jet, 45pilot, and needle at the leanest setting. My target head temps will be around 360-380 so probably a 195, or a 190 main...

So just got my SR going. Very simple setup with a bunch of cheap parts to I wasn't expecting much out of it. My goal was around 50-55 mph with decent low end. So here's my list: Malossi 70cc sport CT intake manifold Mikuni tm24 Some cheap eBay pipe (don't know the name sorry) Koso variator 2k red cl...

i wouldnt worry about a title or regristration. a bill of sale will be nice to have but in sc you dont need anything. ive had the cops tell me a need to be registered and have a tag and all that jazz but dumb sumter cops have no idea what you need or dont need. and for the moped tags the DMV does no...

well then what kit did i get? because its not the same as the stock spree. and it fits and halfway runs.....
http://www.ebay.com/itm/HONDA-NQ50D-SPR ... 66&vxp=mtr

so i ordered a replacement kit for my spree off of ebay thinking it was for the spree but the kit is a little different from the stock one. the piston isnt caved in and the exhaust port is much larger which is great with me but now my problem is that it needs to be rejetted for higher compression an...