Honda Spree and Elite 50 Forums

there's a honda symbol right under the speedo
the paperwork says it's a 1988 honda
japanese import

it'll be a few days until i can get back to take some engine shots
i'll post them when i can

perfect
if things don't pan out with the other avenues, i'll follow up on this !

you have been really helpfull, thanks

next question, for a later project....
which muffler would look for ? the exhaust is the same as what other engines ?

those jet numbers are a good start, I live at sea level too

a ton, great !
which ones ?
and i say that, but i have just had a private message with bear, and been talking with Steve from VTCycle
so i think it will all get figured out

thanks !

what size jets do you run ? you're on the east coast, but probably close to the same altitude as me i haven't had much luck finding the rebuild kit for this carb the problem with that place is all the parts i need are half as much as a new one, plus they don't have the bowl gasket which i really nee...

I'm looking at doing something it has a 28mm CR80 carb on there right now i think the main jet is high, but i can't recall exactlly what the number was i had hoped to go with something new from the intake to the filter this carb is from 1982, i thought it has been hard to get parts for the scooter !...

Finally have a few photos to put up
it was half apart, but gives you the idea of what it is supossed to look like
The papers say it is a japanese import, does it have a name ?

i got it post mods, and am now trying to get a little more out of it it ran ok when i got it, and has since started to be a bit unhappy so far it has a new clutch and spring, and new rollers i am going to get a new carb (this one is missing parts) and a new intake hopefully that will keep it all hap...

does that same info apply to the 80CC ?
i see a lot of stuff on ebay stating NOT for AF05
is the 80 also an AF05 ?

I'll look again after work
take the panel off and make sure i scrub it a bit to see it better

Thanks

thanks Pat and Swimming

i will contact Tazland and see what i can come up with

The code on the engine is: HF01E is that the right code ? the one above looked like a serial number It looks like they built an intake pipe and the box that the reeds SHOULD go into, but it looks empty when i look in from the carb area and the box below the intake doesn't look like it's built right ...

Thanks I'll post the number i saw down there shortly, so i can figure out which engine it is when i look in the homemade intake (not by me) it doesn't look like there are any reeds in it at all just looks like it goes straight into the block it's all very MacGyvered together, so i would like to try ...

Hello I have a 1983 Aero80 (NH80) and am in need of a new carb it currently has a 1982 CR80 Carb on it but it has no reeds and the carb is missing springs I want to replace the whole thing, intake, Reeds, Carb Firstly which engine is in this scooter ? i don't know where to look on the engine to find...

ok so i have a few pictures just have to post them but they had torn half of it apart by the time i got there but we did manage to pop the trunk and find the insurance papers it is a 1988 Honda, japanese import looks like a two stroke it's a nice looking scoot i'll work on getting those pictures up,...

Fair enough
I'll post real pictures tomorrow