Honda Spree and Elite 50 Forums

What's everyone's opinions or feelings about the new arrow pipes?
What rpms are you guys hitting ?

What's your guys opinion on the best clutch for high speeds?
Malossi delta or fly?, Polini, Kelli, stock clutches?

My bike has major jetting problems I believe When I make the bike more rich when turning the screw the bike tends to shoot a lot of smoke out of the exhaust and barely moves then after a bit after the smoke is done shooting out of the exhaust it starts to ride normal but dies out later during the ri...

As for the Polini pipe is that it or wil there be more models or versions of it in the future ?

I'm really Intrested to see which pipe people prefer
I like both pipes but I like c16 a little more but if the Polini pipe performs better I'd rather go with performance over looks

Is there any chance the c16 might be available again ?

Which do you guys think performs better for a 72 cc Polini Corsa set up
The Yasuni c16 vs Polini race pipe

Anyone know the sizes of the two nuts that hold the handle bars down to the stem ?

This is for a Honda elite s

While I throttle once my bike gets up to 40mph and as it goes faster the bike starts to make a rattling noise but only after I hit 40 mph or faster and while I'm holding 1/2 throttle or more It's sounds like it's coming from the pipe side of the bike Anyone know what it could be and I know it's not ...

What gears are good to run to hit about 70

Ok first here's my set up Honda elite s 1996 Af16e Polini Corsa Stage 6 intake 28 OKO carb Rrgs g dash pipe 7.2.1 gears 15% contra spring 4000 Polini shoe spring 36 g weights So I recently changed gears from 8.4.1 to 7.2.1 when I had my 8.4.1 my bike used to go about 68 top speed now I changed my ge...

What are some good parts to help going fast haha just curious like which intakes, reeds, pulleys, ramps, trans, etc just wanna know your guys opinions on the best parts

Ran my bike up to 412 in temp then all of a sudden bike started to acclerate on its own. I used the kill switch turned the bike off flipped the switch back on and the bike started moving on its own again. After letting it cool for about 10 minutes tried to start the bike and bike started and ran nor...

I have a Honda elite I'm running a g dash pipe with a Polini Corsa 28 OKO carb When I use the pilot jet size 60 bike bogs in the beginning only When I use the pilot jet size 55 bike does not bog In the beginning but the bike dies out when I full throttle While running the 55 pilot do I need to adjus...

Oh no I don't I just tighten both the large but and smaller but as tight as I can but it still gets loose. So i should apply loctite on the threading of the stem ? and which loctite do i use ?

My elite s has a disk front set up with the elite s stem and ZX triple tree
The problem is it's been about 4 months since I got the stem out on and now after maybe every couple days after riding the handle bars get loose so I have to tighten the nuts. What's the problem ?