Search found 8 matches
- Sat Sep 28, 2019 10:02 am
- Forum: General Discussion
- Topic: Spree/Gyro parts source
- Replies: 1
- Views: 4429
Re: Spree/Gyro parts source
I've boughten from them. I can vouch - good guys.
- Fri Aug 02, 2019 3:47 pm
- Forum: Technical Help
- Topic: Where to buy oversize pistons
- Replies: 3
- Views: 2684
Re: Where to buy oversize pistons
Thanks! I have already reached out directly to him on eBay since all he has listed is a standard sized piston. Waiting to hear back.
- Fri Aug 02, 2019 12:27 pm
- Forum: Technical Help
- Topic: Removing Speedo Worm Gear in Brake Hub
- Replies: 6
- Views: 4356
Re: Removing Speedo Worm Gear in Brake Hub
I was replacing a SA50.
- Fri Aug 02, 2019 12:26 pm
- Forum: Technical Help
- Topic: Where to buy oversize pistons
- Replies: 3
- Views: 2684
Where to buy oversize pistons
Having a tough time finding a place to get oversize pistons for my NN50 84 Gyro. I have low compression (75 PSI) so getting it started is near impossible.
I would like to get an oversize Spree piston for it but can't find a reliable source... any recommendations?
I would like to get an oversize Spree piston for it but can't find a reliable source... any recommendations?
- Thu May 30, 2019 7:04 pm
- Forum: Performance Technical
- Topic: Spree Stock Exhaust Tip Diameter?
- Replies: 0
- Views: 7971
Spree Stock Exhaust Tip Diameter?
Just got an 86 Spree (verified it is NOT the Iowa Edition). After going through the whole scooter, I discovered that it had the stock jet size (#65) in it but someone cut open the end of the stock exhaust and welded a very large diameter exhaust tip to it. I would like to weld it back to normal size...
- Thu May 30, 2019 7:00 pm
- Forum: Technical Help
- Topic: Removing Speedo Worm Gear in Brake Hub
- Replies: 6
- Views: 4356
Re: Removing Speedo Worm Gear in Brake Hub
After attempting this. I discovered the gears are cut in a different direction so most likely you will cause your speedometer cable to run in the opposite direction.
- Fri Mar 22, 2019 7:15 pm
- Forum: Technical Help
- Topic: Removing Speedo Worm Gear in Brake Hub
- Replies: 6
- Views: 4356
Re: Removing Speedo Worm Gear in Brake Hub
Not worth the price to replace the plastic sheered gear. You can swap the internals from a new Honda Dio 50 unit for next to nothing. Dio uses a different count of teeth so you need to swap the worm gear as well.
- Thu Mar 21, 2019 8:52 pm
- Forum: Technical Help
- Topic: Removing Speedo Worm Gear in Brake Hub
- Replies: 6
- Views: 4356
Removing Speedo Worm Gear in Brake Hub
Hi all,
Has anyone successfully removed the worm drive/gear in the front hub of a Honda Elite or Spree? There is a circular piece that is pressed in from the speedometer cable side that holds the worm gear in. I wanted to see if there is a technique before I apply flame heat to the brake hub.
Has anyone successfully removed the worm drive/gear in the front hub of a Honda Elite or Spree? There is a circular piece that is pressed in from the speedometer cable side that holds the worm gear in. I wanted to see if there is a technique before I apply flame heat to the brake hub.