Honda Spree and Elite 50 Forums

It sounds to me like a carb thing, I have found the carburators to be finicky. The rubber gasket thing will need to be replaced. Did it come from the float pin inside the carb. When my spree would run and then bog down all I know is that I followed some Jerry guy and a the spree manuals directions f...

I started the 85 Spree up today and noticed the same thing as before last fall. I start to drive down the road and no problems. Decent , smooth accerleration etc. Once I meet full throttle , which is about 25 -29 MPH for my Spree. It periodically makes a Popcorn machine like clatter and I experience...

I could not locate the stickers at partsfish. Any other suggestions?

I am refinishing the body of my scooter. When I am done with the painting I want to put on the spree logo stickers so I can restore it to original or somewhat original shape. Where could one get new spree stickers ?

The back side panels are a PCABS( Poly carbonate/abutyl styrene mix) which can be melted and or fused with methel ethel keyton (MEK) from hard ware. Be careful. its toxic and could mess up the panel. A two part 5 minute epoxy on the lightly sanded back side of side panels would also work well. Bondo...

:D Issue: 86 Spree kept running great then carb was getting clogged, throttle would not respond well and engine acted bogged down. Carburator kept clogging after repeat cleaning. Solution: Cleaned carb for one last time( Per Jerry), installed new standard fuel line ($1.50) from hardware and a Briggs...