Honda Spree and Elite 50 Forums

got the new bystarter today. bike runs great!!! well for 50cc's anyway.... started tuning carb.. started at 1 7/8 out...but it was always cutting out on top end just dying for fuel so here is what i did air screw out about 1/2 turn, then idle set so rear wheel doesnt roll.....that seems to be about ...

just being stupid

just inserted the by starter a little too hard, the little black plastic piece that holds the needle on snapped..........$60.00 there has to be a cheaper way. still looking for a used one

steve

ajohn

you still have the old bystarter....i need one for a 1985 spree

steve
fenderworks

oh crap, just broke the autobystarter!!!!! onybody got a used one that works??? oh man

i will post on forsale/buy for the autobystarter

i see the light!!!!!!!!!!!!!!!!!i see the light!!!!!!!!!!!!!!!!!

alright, now i will put it together and seee if the autobystarter thingermijiggerwhatumaycall it works


steve

man,!!!! how do you clean this idle jet, it is for sure plugged, cant see any light comming thru, tried needles, spray

is soaking in carb cleaner for 24 hrs going to help

or is there a special tool to get thru this plug

fenderworks

how fast are these new scooters?

some people say they gp 30 stock, others say 40 stock

fenderworks

thanks guys

i will reclean the carb and blow out all jets again (especially the idle jet--thanks noiseguy)

will keep you advised

steve

ajohn 505 hey i have a post "newbie spree 1985" i read your problem and pulled the autobystarter and plugged it with duct tape....now my spree runs....and pretty good!!! what is this "autobystarter" thing anyway if it runs good without it, why is it there?? just wondering

ok here is what i did as i saw in another post i removed the auto bystarter, and plugged the hole with good old DUCT TAPE the spree runs better that ever, it started immediatly, i set the throttle stop screw to adjust the idle speed....it runs pretty good!!!! so now my question is: what is the auto ...

hey guys i just read the thread below this about bystarter hole plugged thing. thought i would post my problems here. 85 spree first off: 1) where is the idle jet? i have cleaned carb, all holes blown out, bike starts everytime but have i missed the idle jet, i have a manuel- but i see no idle jet a...

hey guys

i am going to post in the technical board, since i read the bypass starter article

steve

ok, have cleaned carb again, oil jet, gas jet. starts everytime, idles verry irratic regular idle then, high idle, then very low idle, then high idle, then regular, then low, then finally stalls a a low idle. anytime you give it gas during this proceedure it will choke out. any ideas???? thanks for ...

how long would it take the crankcase to clear out.?? so far it has been started about 30 times, still smokes a bunch and after 5 to 7 seconds it dies. almost like its not getting gas, yet the carb bowl is full and if i disconnect the gas lines, the gas is pumping out when engine starts....it seems l...

go to any honda shop and ask.......there is a big difference between 2 stroke oil and 2 stroke injector oil............injector oil flows better........2 stroke oil is meant to be mixed in gas directly......it will now flow as welll


fenderworks

steve