Honda Spree and Elite 50 Forums

This is not just a standard vacuum line...This line has to be gas/chemical proof and has to reach a certain psi proof...On top of that, it has to have a certain size inside diameter (which is smaller than usual lines) so that it fits tight on both fittings and it maintains it's higher pressure of ai...

So, I am almost done putting the engine on my 83 Aero 50 project together but need to get a hose that goes from my oil pump to the carb...I think it is the fuel line...From what I understand, it is a high pressure hose that has to be clear so that I can look at the bubbles in the line while I bleed ...

depends on what your taking gas isnt cheap Well, I have a 98 Civic hatchback which gets 35 mpg+ so it should not be that bad..so you guys say yay huh? I say its funny you're thinking of transporting it in a civic.. :lol: Everyone does whenever I transport anything in my beloved Civic hatchie. They ...

justinnielsen01 wrote:depends on what your taking gas isnt cheap

Well, I have a 98 Civic hatchback which gets 35 mpg+ so it should not be that bad..so you guys say yay huh?

Update! Got most of the engine put together! Just need to replace the one line that goes from fuel pump over to carb...Very tiniy inlet/outlet and cannot seem to find one like it...Once I find it, i will refill oil and gas and give it a whirl...Replaced started relay and CDI unit so If I can get it ...

Well, I have a similar project going on now...Has been very time consuming but now putting the engine together to see if it starts...I needed most of my parts and got them through asking ebay sellers that had the 83-84 parts if they had anything else as far as body panels...This one guy had nearly e...

1985 Honda Aero 50 that runs fine
Nice condition in black
$250

What do you guys think? Would you do it even if you already have 2 scooters, one is a project waiting to be finished...

I've gotten my OEM parts from discounthondaparts.com. CHeapest prices I've seen and got my parts in little time and they seemed to have everything I needed which is for an 83 Aero 50...

6. Fix crack (JB Weld) on fan side Is this around the muffler mount? If so, I'll take a picture tonight that shows how mine was fixed. I had to have it welded. JB Weld won't hold it (been there done that back around 1991) - there's too much vibration and weight on it. Well, It's the piece behind th...

OK... So now I have replaced piston rings, replaced gaskets with new ones around head, port and polished intake header pipe, replaced gaskets on header pipe, replaced belt with new OEM one, replaced gasket on drive cover, replaced spark plug, drained oil and fuel. Next steps are to 1. replace oil, f...

I'm just going to buy a couple 16x13 rollers and see how they fit...I need to buy them anyways for my finance's Met II.

Is this a sure answer? Anyone out there with an 83-84 have the right answer?

Any one know? I prob should replace them once I get to them and would like to know if they do, what size? 16x13, 15x12? Also, what weights are stock on this thing?

OK Cool...I'm just going to go buy this one at Sears...it got great reviews and the maximum torque is 900 in lbs which seems alot for n impact gun! Not bad price either..

I'm trying to figure out if an electric impact gun would be enough to unscrew both pulley bolts for my Aero? Any suggestions out there...I already found out a couple tricks from searching but just checking to see if people have new suggestions...