Honda Spree and Elite 50 Forums

Just look for a 94+ elite. I find them from time to time around tampa. hmmm i wonder if the AF16 will bolt in with out issues? Yes it would. Would hook into wire harness without any problem. From my roller-coaster ride with the Af05, i wish i had just dropped in a dio from the start. As it stands no...

hmmm i wonder if the AF16 will bolt in with out issues? Yes it would. Would hook into wire harness without any problem. From my roller-coaster ride with the Af05, i wish i had just dropped in a dio from the start. As it stands now, the kymco zx50 engine that i have in there pulls well up to 40+ wit...

Yeah man, i have a bunch of extra odds and ends if you ever need anything, hit me up.

mousewheels wrote:Sym DD50

BTW - Good idea - what do you plan to do with the info?

It all part of my master plan. Mwuahahahaha...

But really, just curious about what other engines are legitimate swap candidates.

It's not steel - it's aluminum, i was wrong But it is hard and solid. Nothing like what i replaced it with. The new ring has only been installed/compressed once. here are some picks. http://img64.imageshack.us/img64/1550/07292010102.jpg http://img138.imageshack.us/img138/6538/07292010103.jpg http://...

C3Killer wrote:Yes, stock rims are steel. (magnet + stick = steel)

My bad.

How about polished steel?

Why not media blast them (or even pressure wash) and then 'polish' the aluminum? It wouldn't be chrome, but it would be still pretty cool. You could wax it and it might look good for a few months. then re polish and the like.

Man sounds like a whole lot of work when you write it out.

I hear these occur often in the Ch150/250's. So the bike came with an exxhuast that sounded like a locomotive so i changed the gasket. The "gasket" that came out looked like a 1/4" right of steel that was shoved up in there. no aluminum gasket. I thought it was crazy with a felt circl...

I am trying to adjust my valve timing, but i am not doing very well. Does anyone have any tips or advise?

What is a graduation as it pertains to the markings on the intake and exhaust adjusters?

Probably need to soak the carb and spray it out again.

Well, i'm at a loss. It feels like a clogged exhaust, or a fuel issue, but I can't say much more than just that feeling. If it doesn't but putter a bit when there is fuel in the cylinder and air can get in, then air can't get out. But i don't know as much as you about this particular engine. How lon...

Have you tried spraying Wd-40 in there to act as starter fluid?

Are you running a stock airbox? Is the filter clogging the air?

pat23 wrote:The exhaust is blowing fine. What else could it be?

Is the spark good and blue when you turn it over?

How old is the Gas?
What scooter is this?

What is the specific compression psi?