Honda Spree and Elite 50 Forums

That would probably work. Remember the more you shift and move your floor board around the more its going to "crack" the paint. Mine is rubber, but I think this would work for it. I would go to your local auto parts store and just ask them what they would use. Home depo might be better too.

burnt_toast wrote:can use 10w40 regular car oil or 75w90 gear oil, either is fine

Thank you so much!
Im going to try it tonight to see if it will make it run better.

Greetings: Next time you have your belt off, give that rear pulley a spin with your hand and watch it freewheel for several seconds. Thats what the motor turns. Now spin the clutch bell and notice that it moves your back wheel. The clutch pads connect the two. The speed of engagement is controlled ...

I have a 50cc Gy6 Chinese make. What kind of transmission fluid should i use? Just regular automatic fluid? or is there some kind of scooter/motorcycle kind?

Greetings: Yesterday you posted this in Builds: OK, I put the new CDI in and I got a 8mph boost with a passenger. I got a 12mph boost with just me Im putting the 9g weights, the perf. clutch, and the new spring on tomorrow So what you're saying, if it went 30 for a while, is that your previous top ...

jesse8931 wrote:you could have done the cdi mod for free
http://www.scootertherapy.com/cdiboxcutpage.html

ya but it wasnt too much

Ok, I installed a no rev limiter and I noticed a increase in speed. Then I put on a "performance" clutch, a 2000 rpm clutch spring, and lastly 9g weighs. Its on a 50cc gy6 Chinese motor. When I was taking the clutch apart I somehow managed to bend the pully thing. I bent them back slowly, ...

OK,

I put the new CDI in and I got a 8mph boost with a passenger. I got a 12mph boost with just me
Im putting the 9g weights, the perf. clutch, and the new spring on tomorrow

Spreetard wrote:

Spreetard wrote:Flying Daytona Xtreme 50cc... is that a chineese gy6????

so...........

yes?? gy6???

yea its a chinese gy6, sorry my computer was down for a bit and I couldnt respond

oh ya, since its yellow I named it Bumble Bee off of Transformers. I got this to put under the brake light. I think it'll show my passion lol

http://cgi.ebay.com/ebaymotors/ws/eBayI ... MEWNX%3AIT

Im modin a "Flying Daytona Xtreme 50cc"

Heres what Ive got:
9g weights
perf. Variator
perf. clutch.
Perf. air intake
per. carb
2000 perf. clutch spring
kevlar belt.

It goes 30 stock. SO what do ya think? How fast do you think it will go without a gear change or a new exhaust?

I wish it was a honda elite but its not, and I dont know where to look for help with it.

Hello, I recently bought a bright yellow 50cc Scooter. The motor is a GY6 (prob. a fake). The carb was shot on it so I bought a new one, when it arrived I realized it was for a 150cc. So I have a few questons 1. Is that going to be too big? Im planning on putting a 80cc bore kit on it (if thats even...

I got the clutch today and the weights. I just have to figure out how to put them on. is there a guide anywhere?

And I can mix different sixes of weights?