Honda Spree and Elite 50 Forums

That is very helpful, I'm going to do a bit of research on the wire colors on the cdi. Thanks for the info, that should definitely save me a few bucks and a headache or two. Thanks!

So the malossi cdi i have is useless if i use the sb harness, and the wires from the stator seem different, any suggestions?

I have built a AF16 to swap to my 88 sb50p. With the exception of the motor mount fabrication does anything else need to be switched? Can the existing wire harness be used?

The jist of it is that I used a couple mm gasket measured the distance from the top of the Piston to the bottom of the exhaust port, the top of the piston to the top of the cylinder then compensated by torque'n the head down and constantly checking the top of the piston at the exhaust port. Hopefull...

I have built an af16 with 44mm mini stroker, polini corsa, polini clutch,polini variator, 28mm oko carb and intake and a v8 cruzzer exhaust. I'm looking to do my gears, secondary and primary or at the least primary. I'm looking for the best of both worlds! Acceleration and top end. what should I be ...

What is the wiwhy difference???

Enough said! Thanks!!!!

I left this out. this is a sb50 front end swap.

Are Metropolitan forks the same as Ruckus forks? Not the stem, The width between shocks For the purpose of a disk brake conversion. let me know!!!

That's a huge help,Thanks guys!

Will a 2009 ruckus rear wheel fit a af16 engine? If not what years and model should I look for??

I already built the engine but still have the stock crank. what's the deal, ruima a piece a junk?

Come on guys!!! With everyone one here I thought I would get some help!! I know I have seen someone post what I'm asking for now but I can't find it!!!!

Thanks for the input!!!! Went with the v8 cruzer!!

I have a 88 elite e/sb50 and have built what I think to be a pretty decent af16, my question is what do I need to do to attach that to the sb50 frame (motor mounts,wire harnesses,ect)? All input is welcome!!!!! Thanks!