Honda Spree and Elite 50 Forums

About done with this build :D I finally got the tail assembly for vt cycles. i tore my scoot apart the other day cause it wouldnt run.......after changing the cylinder twice it was a bad spark plug :P will be installing tail and tuning a 21mm arreche to see if i get any better performance than the 1...

i have adjusted my 21mm a million times and it still spits gas out the overflow. your float probably needs to be adjuated yes but these carbs are so cheaply made even the keihin pwk is the cheapest carb honda uses. i have gone to arreche myself the Oko is just a headache sometimes

he may be talking about the restriction in the header where it bolts to the cylinder

while it is running pull the vacuum line off the intake manifold for a secondand rev it up and see if it is still as bubbly. if it's rich gom bystarter it should run a little better with more air like when you ran it without exhaust it was sucking ai in the cylinder instead of reusing the extra fuel...

order air filter dom Honda and it comes pre oiled just pop it in. order a cheap bystarter for Chinese gy6 off bay for around 8 bucks. if it ran good with the exhaust off and the plug is wet when you take it out and it starts easy then I figure your bystarter isn't working properly. generally if it c...

it's never a good idea to just drill holes in your exhaust. the engine needs a certain back pressure for scavaging and stuff. don't think it's so important on a 4 stroke but a 2 stroke will lose power

thanks mike. I know I need an exhaust and side panel with lock on it. ignition switch is bad and I am pretty sure imma need the stator. petcock too. not sure about anything else till I get it sparkin

I tried both settings with all wires. at 1k yellow and white pegged out and the red black still no reading at all. Andhra it's an analog meter

got this scooter the other day for 80 bucks supposedly all that was wrong mechanically was bad cdi. Well it was missing pwtcock and side cover too. petcock I made a temp fix with a manual valve. it was barely getting spark now none . check resistance. yellow at 10x is 0.1 and white is 0.1 bluelyello...

Not exactly sure, somepeople on this forum say 45 can be reached but I dontonow how with stock pipe, carb etc. maybe if you opened up the intake ports etc I did all kinds of tuning on my stock and never got it past 41 but I am notthat great at trans tuning andi didntuse 90/90 tires.the 43mm kit from...

I wouldn't say definately 45 more like 40

I would try a junkyard for the gears etc the bearings hit ebay or scrappydog

went to the junkyard today. as it happens 86-87 aero 50 front turn signals will fit the se50 you have to shorten the wires and add a female end to the ground otherwise bolt on

the heat gun should clean the red inner plastics up nicely. i was suprised myself how easy it was to do and how well it looked afterwards

Can someone post up some detailed pics of their 86-87 aero front turn signals and 87 spree front and rear signals? trying to figure out if they will fit the 87 se50 elite. i know where an aero is at the junkyard just dont wanna make another burnt trip. they were closed today after i drove all the wa...