Honda Spree and Elite 50 Forums

Time to finish the second Spree and get the Jog together!

Mods are: Keli variator and speed pulley with 6, 7g weights, 84 main jet, and Technigas pipe. Pretty happy with that.

Next up, 1000 or 1500 clutch springs and contra A.S. required.

Step 2 completed:

Kelli pulley and variatiator installed, seeing just over 42mph gps!!! Ima at least right where the Elite S is, I did get over 47 downhill crossing the freeway

eclark5483 wrote: ↑Fri Sep 27, 2019 7:06 pm Post office is open on Saturdays, quit making excuses ya beatnik.

I'm glad everyone is on-board with my assessment!!!! LOL

Ok, I'll go that route. I do have SB50 cages as well that I got with the intakes. I will use the known good reeds that are currently on the bike (85') and transfer them to the SB50 cages . Thanks for all the help. As any new addiction, I'm learning the nuances here. I'm fully capable of doing all th...

Looks like the reeds and gaskets I planned to buy won't be available until noiseguy returns from vacation, anyone know where I can get new reeds and gaskets relatively quickly? I will be tapping the SB50 intakes for the oil line I got tomorrow and would like to get them installed I have the reeds th...

Not familiar, those were early 80’s right? Fill me in.

bonesv wrote: ↑Thu Sep 26, 2019 8:55 pm Yea, that’s bad planning on his part.

I know, right!

I need his reeds an gasket off eBay and he has the guts to take a vacation!!!!! Unreal.

That's exactly what I am looking for more overall pull to speed, if I get 2-3mph top speed with the milling and the SB50 reeds that would be beyond expectations. That would pull me into the low 40's on level ground on the bike with the speed pulley. When I swap I am changing the springs and have a b...

Yeah, I know how to get to it. I am going to try it stock, then proceed after that, thanks for sharing your experience. If mine does the same I will know which direction to go!

I agree 100%, the speed pulley is not good for a guy my size, so most likely I’ll end up with one of each, to be honest, I’m betting I end up in the 37’ish range with the work I’m doing and the 13T, MLM, piston, reeds, intake, milling etc., and be more tolerable off the line. Keep in mind the wife a...

I’m gonna pin that speedo on flat ground one way or the other

Even if I have to drill out an “intake hole” in the intake side of the piston and up-jet. That’s an OLD one...

It will be interesting to see how this one runs with the 13 T instead of the speed pulley, SB50 reeds and intake came today, guess we will see how good my tapping skills are to plumb it for oil.