The place to discuss rides, accessories, or whatever is tangentially Spree/Elite-related
Moderator: Moderator
Scooterspal
Goped
Posts: 70 Joined: Tue Jun 03, 2008 4:31 pm
Location: New England (Connecticut)
Post
by Scooterspal » Mon Jun 30, 2008 9:54 am
Wonder if there was ever any after market updates to the foot rack for the Spree? Some type of rubber mat that made it not so slippery when wet would be ideal.
I saw somewhere where someone had replaced theirs with diamond plate but that would still be slippery, I would think. Do they make that it a matte finish for such a purpose? It could be traced, cut and then attached to the top of the existing rack with spacers through to the plastic underneath.
Any one had any other solutions?? Pictures you can share?
mopedman
CB900F
Posts: 1214 Joined: Mon Jul 23, 1973 10:24 am
Location: sterling Heights MI
Contact:
Post
by mopedman » Mon Jun 30, 2008 10:36 am
Honda had a floor mat option for the spree they are on eBay every once in a wile they go any from 20 bucks to 80 bucks
Michigan Moped Mafia founding member
2005 Yamaha Zuma
1985 Honda Spree
1978 Honda Express
D-fog
BMX
Posts: 46 Joined: Sun May 25, 2008 8:31 pm
Location: Downriver, MI
Post
by D-fog » Mon Jun 30, 2008 10:00 pm
I've been looking for a floor mat for one for a while, I think I might just forget paying too much and try to cut a pre existing rubber mat maybe...
GIJoeBob
Elite
Posts: 769 Joined: Thu Aug 23, 2007 4:40 pm
Location: Nacogdoches, Texas
Contact:
Post
by GIJoeBob » Mon Jun 30, 2008 10:42 pm
I sprayed my Elite floor panel with truck bed liner.
D-fog
BMX
Posts: 46 Joined: Sun May 25, 2008 8:31 pm
Location: Downriver, MI
Post
by D-fog » Mon Jun 30, 2008 11:55 pm
GIJoeBob wrote: I sprayed my Elite floor panel with truck bed liner.
I thought about that, but I was a little unsure of how it'd look against the raised floor pattern. Do you have a picture?
GIJoeBob
Elite
Posts: 769 Joined: Thu Aug 23, 2007 4:40 pm
Location: Nacogdoches, Texas
Contact:
Post
by GIJoeBob » Tue Jul 01, 2008 7:27 am
D-fog wrote: GIJoeBob wrote: I sprayed my Elite floor panel with truck bed liner.
I thought about that, but I was a little unsure of how it'd look against the raised floor pattern. Do you have a picture?
I will soon, I am almost done with this scoot.