Bumble- Bee 2 (after burnt_toasts)Added Pics!!!

[toboggan]

Well i got my 2000 Elite S SA50, about 4700 miles on it now,

I have a Keli vari, with a kymco ramp plate. =43+MPH

My hopes and dreams for this thing is as follows..

Ruima 51mm Kit
CT Manifold
Kiehin PE 26mm carb
Adjustable Throttle Cable
9.1:1 Gears
YWS V8 Exhaust.

Looking for about 60 out of this thing!!

[burnt_toast]

That sounds like a GREAT setup!

Good luck with the build and hit me up if you have some q's

[toboggan]

sure thing, thanks alot burnt!!

[oliveskate]

Sound's pretty nice, some photos would be cool.

[toboggan]

I'll get pics up, they're in another thread. I'll get them up later tonight.

[Limp1144]

Great Build let me know when you start it.

[toboggan]

Ha, Tommy i'm sure you'll know!! I gotta get my parts somewhere.

[toboggan]

Here's to a re-birth of my build

Just ordered the following

Ruima 51mm bbk
ruima clutch
ruima variator
5-7g roller weights
race bell housing
yws v8 exhaust
26mm OKO carb
CT Mani
Adjustable throttle cable
1000,1500,2000 RPM Center springs and clutch springs
8.4:1 Gears
Jet kit
and i think that's about it. there may be more i have forgotten.

[Limp1144]

getting the order ready for you.

[toboggan]

so im going to be putting on the 28mm oko carb tomorrow. i have a pod filter, the Ruima 51mm bbk, a yws v8 exhaust. isn't broken in or anything yet!

All i want are some ideas for jetting to start off with! Any help or ideas are appreciated!

Thanks!

[bakaracer]

52 pilot 132 main needle clip 1 up from middle air fuel screw 1 5/8 turns out as a starting point.if it has the power jet,unplug it.

[bakaracer]

Double check the compression and make sure its not more than 135psi

[toboggan]

Alright! i'll do that! How do i go about installing the throttle cable in the carb? couldnt quite figure that one out yet!

Thanks bakaracer!

[toboggan]

[Limp1144]

Looks really nice where did you get those parts