66SIX Spree Build / YES IT"S FASTER

[Mystic]

I like how you always pay attention to detail. Hook a brotha up with a seat cover

[mousewheels]

Another nice one 66Six

[donut]

Another WOW!

Get rid of the purple...

Spree sticker should be replaced with .... Six...
and that d*** purple strip on the seat ...but other aspects of the seat...wow again...

congrats picasso six ...

[e-Pirate]

I'm lovin' this one...

[66SIX]

Another test ride ...
more pics .

[66SIX]

Back to work .
Made a side cover .

[66SIX]

Yes I know it looks goofy .

[66SIX]

Thats it Im done ... forget the other side for now

[66SIX]

I like how you always pay attention to detail. Hook a brotha up with a seat cover

I bought a spree w/ that seat ... and always wanted to use it but the purple ? ? ? After repainting the flame red it was a lot better
as for re-doing the purple pipeing maybe later its a pain in the @ss.
Thanks for the comments :

[DeathByFox]

Awesome scoot. I like that purple stripe in the seat.

[tazland001]

Need some lights behind the mesh. It would look nice with a soft glow.

Taz

[mousewheels]

Need some lights behind the mesh. It would look nice with a soft glow.

Yeah - couple of Nixies set to 666, LEDs good too!

Nice photo from the 'net...

nixie_blue.jpg (69.88 KiB) Viewed 5072 times

[Bear45-70]

You are aware that the no rev limit CDI was a waste of money, aren't you? The Spree already has a no rev limit CDI from the factory and it is a better quality CDI to boot.

[66SIX]

OK Tazz / Mousewheels ..I actually did some tests w/ lights behind the side screen cover Its was underwelming to say the least
the real kicker is when i noticed sparks and smoke and some flames ...I was just testing and only stuck the wires on the battery terminals
I tried LEDs then I tried an old turn signal (for more foot candles)...somehow one of the leads was shorting out to the frame and I was wondering why it was getting so hot ???
Yeooow look out ziiittt zittt I tried to pull the wire off but it was red hot and sparking another thing I painted the frame black so there is not much to reflect (catch) the light .
The 666 lamps is a great idea but the mesh is rather small so I don't think it would read well , still thanks for the suggestion (maybe if they were back a bit ?)
OK Bear busted your right on the CDI I only used it for looks the case is a blue aluminum and I just thought it looked cool and I had cut the air filter case off and had an open spot where it
seemed to fit well .
Here are some bad fuzzy photos of what the lights looked like .before the wire shorted out .
Again there is so much black nothing reflects the light / notice the amber on the muffler and on the fender at the top is the lens of the signal light I was testing with .

[66SIX]

Also on the subject of lighting I wanted to put LEDs behind the muffler cover .
I have some heat shield material from a company in Austraila and it would probably not be easy to get information on the temps. so close ?
I also had concerns running wires or ground the (- )to the frame and just run a (+) I might have some high temp wire but something so close to the muffler
I don't know ...