Honda Spree and Elite 50 Forums

Might need adhesion promoter for plastic to get it to stick. Sometimes primer will make it work but I had an auto body supply shop tell me that for bare plastic that's the trick. I have some but have yet to try it as I haven't had to do any bare plastic yet. I find that as long as I get the surface clean with acetone properly everything is good.

Thanks for the tips guys, I used the krylon fusion on my ch80 spree paint job and was happy with the results so I'm using it again. Prep is always the key to a good paint job, I usually heat up the surface with my heat gun and also warm up my garage with a space heater.

Doing some body work on the bubble I did with my heat gun. I used Fusor plastic filler, sanded, then a bondo top coat, still need to sand down one more time.

Greetings;:

A Power Bulge. Nice.

Repaired a broken mounting hole on the side plastic, hope it holds.

I just drilled new holes and used zipties lol, guess the qaulity will really show afterwards. Wish I actually had a thing for looks, but im more of if it works, use if it looks good so what. But its still eye candy to have looks too. I would still pay for the eye candy, but yet its not my style. Good build so far and that power buldge isnt the only budlge that thing is sporting. im refering to the monster motor

Before I was using large washers to hold the panels with broken mounting holes, it worked.

It takes a lot of patience to make things nice, at some point you call it good enough because you just want to ride. That's why I usually do projects during the winter, now spring is kicking in though.

Getting ready to paint the body parts.

Greetings:

I'm confident your scooter will run strong and look good. The pains you take will be totally worthwhile.

Wheelman-111 wrote:Greetings:

I'm confident your scooter will run strong and look good. The pains you take will be totally worthwhile.

Thanks Wheelman, Building up scooters is a fun hobby.

Paint is done!

Address please hahahaha

Looks amazing, that power budge and gloss white <3

MrJumps wrote:Address please hahahaha

Looks amazing, that power budge and gloss white <3

Thanks man, turned out pretty good for rattle can paint.

I decided to put a pipe on my nh125, it has to be custom fit because no one makes pipes for the nh125. The best option was a pipe made for a dio, this is the cheapest I could find that had a silencer.

Is it a 125 pipe? Freaking sweet build. Spaero 125!