Page 3 of 6
Re: 66SIX Spree Build / YES IT"S FASTER
Posted: Thu Aug 11, 2011 8:55 pm
by ute
I like light under the muffler heat shield looks very cool ( how about header wrap on the pipe for heat insulation )
I'm still not keen on the color of the side mesh ....maybe dark red to match the vent cover mesh
Re: 66SIX Spree Build / YES IT"S FASTER
Posted: Fri Aug 12, 2011 6:56 am
by 66SIX
Pre-mix if you don't have 2 stroke oil your f u c k ed.
How did I fix that problem ?
I had a space where the old oil tank was ....Duh....
Re: 66SIX Spree Build / YES IT"S FASTER
Posted: Fri Aug 12, 2011 7:11 am
by 66SIX
Stopped in at the dollar store ,They had mesh pencil holders ,And looked about the same size as my foam air filter
Guess what they cost ? ....$1.00
A little red paint cut out a skull stencil even less white paint ... Done .
OK I did have to tap the top of the carb to put a 7mm screw in to keep it from falling off .(took less than 1 min.)
Re: 66SIX Spree Build / YES IT"S FASTER
Posted: Sat Aug 13, 2011 3:57 am
by 66SIX
20 Bucks and it's removable.
Re: 66SIX Spree Build / YES IT"S FASTER
Posted: Mon Aug 29, 2011 11:40 am
by burnt_toast
Going great until you added that box, that thing is hideous.. LOL
but i bet its functional
Re: 66SIX Spree Build / YES IT"S FASTER
Posted: Mon Aug 29, 2011 12:46 pm
by mopro logan
Nice scoot I like the meshing.
Re: 66SIX Spree Build / YES IT"S FASTER
Posted: Mon Aug 29, 2011 12:58 pm
by motormike
.....Ditto on the box......even took my milk-crate off the elite.....got tired of the look.....LIKE the mesh 100%....it's like a naked bike, wearing see-thru teddy....ooh-lah-lah
Re: 66SIX Spree Build / YES IT"S FASTER
Posted: Mon Aug 29, 2011 1:11 pm
by motormike
....... 
......case o' beer, bag o' ice, case o' beer, bag o' ice, case o' beer, bag o' ice,.........I hope I can remember why I'm riding this Spree to the store........case o' beer, bag o' ice, case o' beer, bag o' ice................
Re: 66SIX Spree Build / YES IT"S FASTER
Posted: Mon Aug 29, 2011 11:32 pm
by mopro logan
motormike wrote:....... ......case o' beer, bag o' ice, case o' beer, bag o' ice, case o' beer, bag o' ice,.........I hope I can remember why I'm riding this Spree to the store........case o' beer, bag o' ice, case o' beer, bag o' ice................
That is the only plus to the box lol
Re: 66SIX Spree Build / YES IT"S FASTER
Posted: Tue Aug 30, 2011 6:16 pm
by 66SIX
Well your right on the case of beer and bag of ice .The trunk is removable.
I added more sh@t to the bike Red LED and amp meter & red reflector tape to rims .
Re: 66SIX Spree Build / YES IT"S FASTER
Posted: Tue Aug 30, 2011 6:19 pm
by evilone
Very cool
Re: 66SIX Spree Build / YES IT"S FASTER
Posted: Wed Aug 31, 2011 12:18 am
by mousewheels
Pretty bright LED's, show up well in daylight. How about a night shot
Re: 66SIX Spree Build / YES IT"S FASTER
Posted: Thu Sep 08, 2011 6:11 am
by 66SIX
Found an old pipe and figured ...Give it a shot.
I have another thing to put on my do not do again list ...Never try to weld a header or make mounts for a Exhaust pipe .
The metal on the side is the unfinished mount .
On the first test run I got about 1/2 a block before the pipe ripped off the header (should have made a mount & thicker welds )
So back to the welder and thicker welds and deffinatly make a mount .
I noticed a bit more power but it's very loud .Hope to have it finished tomorrow .
Re: 66SIX Spree Build / YES IT"S FASTER
Posted: Thu Sep 08, 2011 9:01 am
by swimmingfree
looks grate and not my grampa spree but didn't like it innhow..
one question why is the back finder still on ??
your not using the air filter so the only thing in the finder is the coil i think??
swimmingfree
p.s.
with the new pipe you wont have a spot to bolt the back of the finder on to innhow
Re: 66SIX Spree Build / YES IT"S FASTER
Posted: Thu Sep 08, 2011 10:42 am
by mopro logan
I like that pipe on there where did you get it.