Honda Spree and Elite 50 Forums

well i paid 425 for it. put only 30 miles on it then the belt broke. was told the last owner put a new one on. well the nut on the crank striped the crank threads and i decided to put a gy6 50 i had laying around in it. scooter right now only goes 30mph. just order a rev limit delete and a new dlh dlh variator. ill post pic up later.

not jareebs, but heres a gy6 50 swap spree.


heres jareebs running:

http://youtu.be/NW0JgUddSdQ

I've got a gy6 engine sitting. I would love to see the mods required to get that engine on a spree!

graphite9 wrote:You need some serious reinforcing of the frames with that much of a stretch. I can feel my gy6 elite frame flex WITH reinforcements. Especially a hard tail.

old red was build for racing, doesnt flex anymore, engine flex the frame and shes good to go now.

little update. found out that the free gy6 50cc i got had a 80cc bbk on it. but it only went around 30mph. after the first year i tried a brand new carb same jet. and boom! it runs like it should. manged to hit 46.7mph on gps last sunday. ill take some pictures of what it looks like tomorrow.

sorry the pictures arent very good. its storming out side right now. ill have the body off this weekend so ill post better pictures of the engine mount.

Meh

haven't been on here in a while. installed a huge list of parts. big valve head, big cam, new rings,and have yet to install upgears and i plan on raising the compression to run on e85. but i did hit 60mph going down a hill. i would say the scooter hits 50mph or so on flat ground very quickly. no gps times yet.

spree is getting supercharged with a smog pump off a rx7. seen may videos on youtube with great results.

What're you going to run the smog pump off of? The ground, tire, or attempt a pto conversion.

smog pump super charger???



Dude you're going to make me search google now for this elusive smog pump...

driving off the crank ill be driving it. bench testing shows that it does compress air. no efi setup yet. i can get it to work with this carb and a few check valves. going out of town this weekend. more work will start monday!! also when i get the bugs worked out ill make a really detailed write up.

got alot done today. almost done with the mounting bracket, just have to weld it up. stores closed to early but i had a belt i could use to make it spin with the engine. it makes a very cool sound!









https://www.youtube.com/watch?v=XuQ3FaA ... e=youtu.be

im not that far yet. the fan is going back on with a shroud.