Honda Spree and Elite 50 Forums

Just figured out a way to get my dellorto 17.5 phva to fit.... and I'm glad cuz a 24mm would have been too big regardless of cheapness. Now I gotta order jets for this dellorto and figure out how to tune it. And I gained auto-choke! I might disable it and go to manual choke tho.

im going to be selling the RT over range rear pulley and belt combo, message me if interested.

Ya just saw lots of stuff on how there a pain to tune. Luckily my parts pile has come thru again. I have a couple mikuni 18mm phbg carbs so I'm gonna try one of those instead. I still don't like the idea of a foam filter but I don't know what else to do. I ain't got a oem airbox and I've got an aftermarket intake manifold. I saw a guy on another forum wrap tape around a foam filter to restrict it a little and he said he dropped a few jet sizes so I might try that.

Found something else in my parts pile too.. a thumb throttle from a quad. I might have to use it, my wrist is going south these days. I broke my arm and later got a bad gash and lost a tendon. My right arm has seen better days haha. I've been thinking about going w a French left hand throttle or a thumb throttle to compensate for the pain.

pic of my final decision (so far) on carbs. A mikuni phbg, an 18mm I think. Came from a tng venice that I got, and I used some parts from an e-ton 90 carb. Has an 85 jet I think. I'm gonna stick w auto choke for now but I might swap that out.

Guess what just came in!!

Finally got my cooling shroud and pipe. Now I just gotta fire it up. I'm finishing up the bar install, I'm gonna use tn'g venice gauge n warning light pod and I'm gonna paint all the blue stuff black.

If I buy a sticker and send it to you in the mail will you put it on your bike?

Like this one?

http://www.ebay.com/itm/FUNNY-WARNING-M ... 1031351586

Its a suprise, not offensive but either you take it and you have to put it on or you dont mu hahaha

Ya I've been kinda afraid of the rust. I oiled up the cylinder walls and exhaust n intake ports when I put it together, but ya I was kinda thinking bout at leads popping the head off and rotating it. It is outside and we've had a storm but I keep the motor taped up so I'll cross my fingers.

Jumps I'll put the sticker on... but I won't promise it'll be visible

Is this it?

Cuz I got it already

benji wrote:Are my pics huge btw? I saw motormikes post about that, I wonder if I'm guilty too... I use photobucket and only go onto this site w my phone.

Thanks for being considerate benji...
My own ineptness of operating computers and modern internet devices is part of the problem of BIG pix too. Like your Yamaha scoot..especially WHITE ! !...rock-on...mm

No prob mm.

Picked out a couple of these beauties out of my non-inventory parts for work. these lights have the same style headlamp as ours, a glass bulb soldered into a glass and metal housing. The shape makes it easy to clean out the little shards of glass after I melted the solder and broke out the bulb. Should work nicely, has a good fit. I don't expect too much long distance light from these bulbs, as there basically a high-powered taillight bulb compared to a newer led headlight bulb, but they should be at least slightly better than the stock bulbs in output and look cooler.