Help! i need some advice.

spree-rider · Post by **spree-rider** » Mon Jun 21, 2010 8:54 pm

So, i have a 86 honda spree that i have been working on and i was wondering since i dont have the expertice or skill to to a BBK i was wondering if Taz's gears and the Vari would work well without the BBk? Thanks, any advice would be aprecaited.

Bear45-70 · Post by **Bear45-70** » Tue Jun 22, 2010 1:43 am

spree-rider wrote:So, i have a 86 honda spree that i have been working on and i was wondering since i dont have the expertice or skill to to a BBK i was wondering if Taz's gears and the Vari would work well without the BBk? Thanks, any advice would be aprecaited.

Sure the gears will work without a BBK. A variator is a different animal since there are none yet available for the Spree. Taz is working on on but it is a bit down the road.

ae86guy · Post by **ae86guy** » Tue Jun 22, 2010 4:51 am

you could also open up the intake manifold or fit a sb50 intake and reeds should make a little difference check out the other posts about intake mods

spree-rider · Post by **spree-rider** » Tue Jun 22, 2010 8:43 pm

Bear: how wel the gears work with the stock bore?

and 86 if i did that would i need to re-jet?

mr pibbs · Post by **mr pibbs** » Tue Jun 22, 2010 9:18 pm

spree-rider wrote:how wel the gears work with the stock bore?

Your take off will be poor. Worse than it is now. Barney Rubble Style.

and 86 if i did that would i need to re-jet?

No. You would not need to rejet unless you did something to the airbox or increased your cubic centemeters with a BBK.

Honda Spree and Elite 50 Forums

Help! i need some advice.

Help! i need some advice.

Re: Help! i need some advice.

Re: Help! i need some advice.

Re: Help! i need some advice.

Re: Help! i need some advice.