reed valves or bad seals ???

bakaracer · Post by **bakaracer** » Thu Jun 30, 2011 4:13 pm

What do you have the plug gap set at?

swimmingfree · Post by **swimmingfree** » Thu Jun 30, 2011 4:32 pm

between 25 and 30 25 lose but 30 don't go in
its running now no good but its a start
what i think happen is because i use a dome piston & the cylinder for that piston and a small packet head the compression was to high .. my gage mite be off got it to run now

i have to fix the crab i strip the hole out not gone just bad enuff to be lose and cant get the crab set have a air leek but at less it will start

well that what i get for buying 3 junk spree to make one
and its ben fun

swimming free

Mystic · Post by **Mystic** » Thu Jun 30, 2011 7:20 pm

that sucks, i stripped the bolt hole on my carb too I have learned my lesson about torque, luckily it only eat half the threads off so it still bolts without a leak

I am glad you got her going man I know you have been pulling your hair out

swimmingfree · Post by **swimmingfree** » Thu Jun 30, 2011 9:08 pm

and then they made taps

so it is not a big deal to fix just got to hope it stop raining out so i can get to it.

swimmingfree

Honda Spree and Elite 50 Forums

reed valves or bad seals ???

Re: reed valves or bad seals ???

Re: reed valves or bad seals ???

Re: reed valves or bad seals ???

Re: reed valves or bad seals ???