1987 honda elite 80 gas blowing into air filter

Trying to get your Spree/Elite to run, or run better? Post your questions here.

Moderator: Moderator

Post Reply
HondaScootinWI
Noob
Noob
Posts: 7
Joined: Sun Aug 21, 2011 2:35 pm
Location: Wisconsin

1987 honda elite 80 gas blowing into air filter

Post by HondaScootinWI »

Not quite sure whats goin on here. the scoot has been sittin about 2 weeks until i got a new air filter, i put it on, fired it up and it drove fine for about ten minutes until i brought it home and turned it off. had a hard time restarting it. pulled off the air box cover and gas was leaking out. it will start and idle for the most part but when throttle is applied of bogs and runs like s***...anyone know what the deal is?
1987 Honda elite 80
1988 Honda elite- R.I.P
User avatar
motormike
Moderator
Moderator
Posts: 5495
Joined: Wed Dec 29, 2010 10:58 pm
Location: Glasgow, KY

Re: 1987 honda elite 80 gas blowing into air filter

Post by motormike »

.....sounds a lot like the float needle has become stuck open....flooding the air box with gas.....possibly a hose into the air box?? ....from emissions hose
RideRed
<(2)Gyro S><Helix><Sym Wolf>
"Live Large - Ride Small"
User avatar
mopro logan
Spree
Spree
Posts: 141
Joined: Thu May 26, 2011 4:52 am
Location: 49660

Re: 1987 honda elite 80 gas blowing into air filter

Post by mopro logan »

I was just working on a gy6 that was doing the same thing but it also overflowed the spark plug to. I would say your float needle is stock open. I had to clean the carb twice the second time I scrubbed the float needle and now it works great.
User avatar
dun rite
Board Supporter
Board Supporter
Posts: 709
Joined: Fri Apr 15, 2011 2:07 pm
Location: Naalehu, Hi

Re: 1987 honda elite 80 gas blowing into air filter

Post by dun rite »

if the float needle looks good then you might try this.

http://hondaspree.net/wiki/index.php5?t ... Valve_Seat

since i don't know anything about the 80 i'm *-u-ming the float needle seat is non replaceable.
taz 50mm bbk, 51g. rollers,1500 c spring
24mm arreche, #20 pilot, E2 needle clip on lower groove
arreche air filter
Naruku intake, reeds & block
v8 pipe
stock gears
trail tech temp & rpm gauges
Post Reply