72cc bbk just installed not reving up like it should HELP
Moderator: Moderator
72cc bbk just installed not reving up like it should HELP
2000 elite s just got done rebuildin with new kit keli vari and clutch and eight to four to one gears. Stock airbox and exhaust(unrestricted) running a 88 main jet. Scooter fires up first kick and idles fine just does not rev up like it should at all gets to a certain rpm just past quarter throttle and just doesnt rev any higher like its governed. Checked plug for spark and even put a new plug and it hasent got me anywhere. Hopefully someone has had this problem i was so excited to put it all together and break it in and it wont even run right.
Re: 72cc bbk just installed not reving up like it should HEL
For1 you shouldn't be reving it up if you just put the bore in. You need to heat cycle the cylinder first.that way the metals can conform to each other. Reving a fresh bore is a good way of stretching the ring lands out. Did you punch the 2nd tab out of the outer cover of the airbox where the air comes into the airbox? If you did then check your airfuel screw adjustment
Nothing like getting stroked!
Thanks to my sponsors
Nos Energy Drinks,themopedcompany.com,nwautoevents.com,Cycle Gear
90 honda dio sp 72cc
87 elite 50 s with 86cc watercooled mini stroke
87 elite 50 race bike mhr 72cc
91 yamaha tzr 250r
Thanks to my sponsors
Nos Energy Drinks,themopedcompany.com,nwautoevents.com,Cycle Gear
90 honda dio sp 72cc
87 elite 50 s with 86cc watercooled mini stroke
87 elite 50 race bike mhr 72cc
91 yamaha tzr 250r
Re: 72cc bbk just installed not reving up like it should HEL
I didnt rev it up right off the bat i would start it let it run for about 15 mins and shut it off and let it cool down did that about 3 or four times. punched second tab out. which screw is it the top one to adjust air to fuel and which way should i turn it.
Re: 72cc bbk just installed not reving up like it should HEL
The top screw is for the idle. The bottom screw that looks like its sitting in the carb body is the air fuel screw. Set that at 1 3/4 turns out.
Nothing like getting stroked!
Thanks to my sponsors
Nos Energy Drinks,themopedcompany.com,nwautoevents.com,Cycle Gear
90 honda dio sp 72cc
87 elite 50 s with 86cc watercooled mini stroke
87 elite 50 race bike mhr 72cc
91 yamaha tzr 250r
Thanks to my sponsors
Nos Energy Drinks,themopedcompany.com,nwautoevents.com,Cycle Gear
90 honda dio sp 72cc
87 elite 50 s with 86cc watercooled mini stroke
87 elite 50 race bike mhr 72cc
91 yamaha tzr 250r
Re: 72cc bbk just installed not reving up like it should HEL
Are you using the stock exhaust?
Nothing like getting stroked!
Thanks to my sponsors
Nos Energy Drinks,themopedcompany.com,nwautoevents.com,Cycle Gear
90 honda dio sp 72cc
87 elite 50 s with 86cc watercooled mini stroke
87 elite 50 race bike mhr 72cc
91 yamaha tzr 250r
Thanks to my sponsors
Nos Energy Drinks,themopedcompany.com,nwautoevents.com,Cycle Gear
90 honda dio sp 72cc
87 elite 50 s with 86cc watercooled mini stroke
87 elite 50 race bike mhr 72cc
91 yamaha tzr 250r
Re: 72cc bbk just installed not reving up like it should HEL
yes stock exhaust with the restriction out
Re: 72cc bbk just installed not reving up like it should HEL
i think its running to rich so i would want to back the air to fuel adjustment screw out right?
Re: 72cc bbk just installed not reving up like it should HEL
yes. In is rich.
2001 Honda Elite
1995 Yamaha Jog
1994 Yamaha Axis
I can't believe
that cop put me
in the backseat
when I clearly
called shotgun.
1995 Yamaha Jog
1994 Yamaha Axis
I can't believe
that cop put me
in the backseat
when I clearly
called shotgun.