2000 Honda Elite SR50
So I put a new petcock on and cleaned the carb but gas isn't flowing.
Any ideas on how I can fix this?
Gas not flowing from tank
Moderator: Moderator
Re: Gas not flowing from tank
Are the lines connected properly? The bottom nipple on the petcock goes to the intake manifold and the top on to the carb.
You can always just suck on the lower line and fuel should flow out the upper nipple.
You can always just suck on the lower line and fuel should flow out the upper nipple.
Bear 45/70
'83 Aero 80 X 3
'84 Aero 80 X 3
'85 Aero 80
'84 Aero 125 X 2
'84 Aero 125
'84 Aero 125 X 2
'85 Aero 50
'85 Spree
'83 Aero 80 X 3
'84 Aero 80 X 3
'85 Aero 80
'84 Aero 125 X 2
'84 Aero 125
'84 Aero 125 X 2
'85 Aero 50
'85 Spree
Re: Gas not flowing from tank
Yeah sucking on the vaccum tube brings gas. Maybe the lines are too loose on the nipple.
- swimmingfree
- CBR1000RR
- Posts: 3357
- Joined: Tue Jun 14, 2011 12:28 pm
- Location: mich.
Re: Gas not flowing from tank
put the end that has gas comming out of it on the carb and suck on the other it shood fill the carb!!!!
swimmingfree
swimmingfree
handicap (dyslexia)
looking for
se50 crank...
SpreJunk 87elite in a spree body
ruckus variator , 3.5 tire , 1500 drive face spring , a 64 bbk ,
8 gram rollers, stock carb , after market air filter and 105 jet
looking for
se50 crank...
SpreJunk 87elite in a spree body
ruckus variator , 3.5 tire , 1500 drive face spring , a 64 bbk ,
8 gram rollers, stock carb , after market air filter and 105 jet
Re: Gas not flowing from tank
Tightening the hose around the vacuum nipple solved my problem.
Thanks everyone!
Thanks everyone!
Re: Gas not flowing from tank
Make sure you nip off the end of those hoses if you didnt replace them. Tightens them up even more!