Quick question on reassembling my carb
How is the retainer supposed to hold the jet needle in throttle valve?
Do you just put the jet needle with needle clip on it inside the throttle valve then press down the retainer?
Or does the retainer get pulled down into the throttle valve by mounting it to the needle clip then pulling the needle into the throttle valve?
Carb reassembly issue
Moderator: Moderator
Carb reassembly issue
1986 Spree Red
1986 Spree Black no Kickstart
1986 Spree Black no Kickstart
-
- Veteran OG
- Posts: 3639
- Joined: Tue May 22, 2007 8:10 pm
- Location: North of Seattle, WA
Re: Carb reassembly issue
That is fine and good. It is good to get the retainer seated before re-assembly.Do you just put the jet needle with needle clip on it inside the throttle valve then press down the retainer?
The spring holds the retainer tight to the needle clip once the entire carb is assembled.
Re: Carb reassembly issue
d*** I have an 86 and I just noticed in the manual now it says not to disassemble these items after 85' model year or it results in damage! I think this should be added to the wikispreedia
1986 Spree Red
1986 Spree Black no Kickstart
1986 Spree Black no Kickstart
Re: Carb reassembly issue
I only disassembled these parts in the first place though because my throttle wasn't functioning properly after I had everything attached to the carb in the proper manner with the slot facing the screw!
blahhhh frustrated hopefully I can figure this out tomorrow or garner some info. from you guys. I was never good at adjusting my brakes on my bmx bike, hate messing with cable linkages !!!!
blahhhh frustrated hopefully I can figure this out tomorrow or garner some info. from you guys. I was never good at adjusting my brakes on my bmx bike, hate messing with cable linkages !!!!
1986 Spree Red
1986 Spree Black no Kickstart
1986 Spree Black no Kickstart
-
- Veteran OG
- Posts: 3639
- Joined: Tue May 22, 2007 8:10 pm
- Location: North of Seattle, WA
Re: Carb reassembly issue
I suppose there are folks which could bend or damage the needle - and have never seen *any* offenders here. I doubt you are one
Here's a pic of the assembly, very little to go wrong on assembly, other than that clip can sometimes rotate on assembly. I press it down with a socket which clears the bore...
Here's a pic of the assembly, very little to go wrong on assembly, other than that clip can sometimes rotate on assembly. I press it down with a socket which clears the bore...
Re: Carb reassembly issue
Yep I can confirm that's how I reassembled it after having issues with my throttle but then I still had very little throttle turn and it did not feel normal. Am I just left to adjust my throttle and should I be doing this with the assembly attached to the carb or detached ?
1986 Spree Red
1986 Spree Black no Kickstart
1986 Spree Black no Kickstart
-
- Veteran OG
- Posts: 3639
- Joined: Tue May 22, 2007 8:10 pm
- Location: North of Seattle, WA
Re: Carb reassembly issue
Slot of the throttle slide 'keys' into the carb. There is an alignment nub in the carb. Guide to assembly is 'angled notch' of the throttle slide faces air filter box.