premix too much oil wont start

eight08boy · Post by **eight08boy** » Thu Mar 17, 2016 6:13 am

I was drunknput too much oil lmk wut u think on fix it

EastCoastCB · Post by **EastCoastCB** » Thu Mar 17, 2016 6:43 am

Most two strokes I've owned will run with quite a bit of oil in the fuel.
If its too bad you can just drain the tank and carb and refill with new stuff.
If you've fouled the plug, clean it up.

eight08boy · Post by **eight08boy** » Thu Mar 17, 2016 9:10 am

Wut size socket was the spatk plug

patthesoundguy · Post by **patthesoundguy** » Thu Mar 17, 2016 11:10 am

I've run engines on 16:1 you would have to have a *-ton of oil before it's not going to start. Might be good to drain as sugested and try again. Also make sure that the fuel lines and float bowl are not full of staright oil, that can happen if you dump oil in the tank and dont shake the machine right away. Had it happen once with my gas bike motor kit, had to drain the oil out of the float bowl on the side of the road. You can use a propane or mapp gas torch to heat the tip of the plug glowing red to burn off any fouling on it. Hold it with pliers or in a vise and let it air cool o it's own. Will be like a brand new plug.

Wheelman-111 · Post by **Wheelman-111** » Thu Mar 17, 2016 12:08 pm

Greetings:

Quoth 808Boy:

I was drunknput too much oil lmk wut u think on fix it

Uhh... Not working on your scooter while intoxicated?

motormike · Post by **motormike** » Thu Mar 17, 2016 3:42 pm

eight08boy wrote:Wut size socket was the spatk plug

the size that fits...can you read numbers ?

frank50e · Post by **frank50e** » Thu Mar 17, 2016 5:58 pm

13/16ths or 5/8s and don't drink and work on stuff it'll kill you or worse your bike.

patthesoundguy · Post by **patthesoundguy** » Thu Mar 17, 2016 5:59 pm

motormike wrote:
eight08boy wrote:Wut size socket was the spatk plug

the size that fits...can you read numbers ?

I left that one alone, figured Id leave it for you Mike

motormike · Post by **motormike** » Thu Mar 17, 2016 7:11 pm

yeah ptsg, I can only hold back most of the time....then I am in danger of exploding if I can't release the pressure occasionally...

Wheelman-111 · Post by **Wheelman-111** » Thu Mar 17, 2016 8:19 pm

Greetings:

Stock spark plug socket is 13/16 American.

motormike · Post by **motormike** » Fri Mar 18, 2016 4:32 pm

Wheelman-111 wrote:Greetings:

Stock spark plug socket is 13/16 American.

How can you say that when the OP doesn't tell you if he's on a Spree or a Sportster ?

1man8scoots · Post by **1man8scoots** » Sat Mar 19, 2016 10:58 am

Ha too awesome.

Wheelman-111 · Post by **Wheelman-111** » Sat Mar 19, 2016 11:37 am

Greetings:

Odd you should mention the Sportster. I once bought Irie-dee-Yum plugs for my twin-plug 1200S from some brand I can't remember. While the stock plugs used a standard plug socket, the exotic replacements required a really weird size, like 18mm deep socket.

Honda Spree and Elite 50 Forums

premix too much oil wont start

premix too much oil wont start

Re: premix too much oil wont start

Re: premix too much oil wont start

Re: premix too much oil wont start

Re: premix too much oil wont start

Re: premix too much oil wont start

Re: premix too much oil wont start

Re: premix too much oil wont start

Re: premix too much oil wont start

Re: premix too much oil wont start

Re: premix too much oil wont start

Re: premix too much oil wont start

Re: premix too much oil wont start