i have a 85 spree. i needed to take off the carb to clean and re-assemble. after i put the carb on i went to screw in the throtle cable into the carb. i out it in the right way grooves into the slot. then when i went to turn the throtle it has all sorts of slack. i dont know if i need to ajust the throtle screw or maybe is it that i moght of assembled the float inside the carb wront. andy suggestion on what i should do would be really appreciated.
thanks
jayrey
Throtle not working
Moderator: Moderator
-
- Spree
- Posts: 167
- Joined: Sun Feb 25, 2007 11:18 am
Re: Throtle not working
Sure you are using the right slot? You should be using the one that runs the length of the slide.jayrey0910 wrote:i have a 85 spree. i needed to take off the carb to clean and re-assemble. after i put the carb on i went to screw in the throtle cable into the carb. i out it in the right way grooves into the slot. then when i went to turn the throtle it has all sorts of slack. i dont know if i need to ajust the throtle screw or maybe is it that i moght of assembled the float inside the carb wront. andy suggestion on what i should do would be really appreciated.
thanks
jayrey
'87 Elite SE50 w/65cc Polini Kit
'84 Aero NH125
'84 Aero NH80
'05 Kymco ZX50
'84 Aero NH125
'84 Aero NH80
'05 Kymco ZX50
- jayrey0910
- BMX
- Posts: 25
- Joined: Thu Aug 02, 2007 6:03 pm
- jayrey0910
- BMX
- Posts: 25
- Joined: Thu Aug 02, 2007 6:03 pm