I have the piston kit and am ready to get the cylinder bored to fit the new 0.5mm oversize piston but I have a couple of questions:
No 1, I want to make sure I don't snap the piston rings when I stick them on, does anyone here have any tips for installing them? I am also slightly unsure which piston ring goes where i.e. which one is top and which one is bottom.
No 2, I was fiddling around with the scooter the other day just cleaning it, and I decided to look underneath the transmission case thing (not sure what it's called) and I saw what I assumed to be the centrifugal clutch cog. I played with this a little (carefully) but when I turn the rear wheel, I hear a sort of clicking sound coming from the rear axle. Does anyone know if this is normal? I can't remember if it always did this, I am just a bit worried because I am scared that in taking of the cover, I stuffed something up.
No 3, can I make my own top end gasket out of standard gasket paper?
Thanks all, I have recommended this website to heaps of people by the way
![Very Happy :D](./images/smilies/icon_biggrin.gif)