Wheel banding

Bobspeed · Post by **Bobspeed** » Sat Oct 10, 2015 3:42 pm

Well my tyre tyres turned up, stuck the rear 120/70/10 on, and wheel wouldn fit

So let tyre down to get it on, and mark out where would be touching, marked it out, and cut it away, runs free now

So now that's sorted, strip it all down for paint, then il do a little build thread on here

kuromi · Post by **kuromi** » Sat Oct 10, 2015 4:14 pm

That's going to look bad-*! :peace:

You're auto choke looks in good nick too.

Bobspeed · Post by **Bobspeed** » Sat Oct 10, 2015 4:36 pm

Sorry dude, forgot to post pic of. Y mount, didn't want much stretch on this one as its running standard motor for popping to the shop

I just used some 20mm box section which brings it back 20mm,and offset off 30mm to centre the wheel again

Second one * pic, but reinforced it a bit

Sneak pic of my forks with my 2" drop

ped · Post by **ped** » Sat Oct 10, 2015 4:47 pm

nice work

you may need a thin cover on the stator?

benji · Post by **benji** » Thu Oct 15, 2015 12:07 pm

I was thinking the same thing about the stator, but I dunno maybe it'll be cool haha. I'm loving the rim please let us kno if your gonna start doing that as a service, I'd totally pay for that!

Rip_City_Spree · Post by **Rip_City_Spree** » Thu Oct 15, 2015 7:16 pm

+1 that's awesome work looking forward to seeing it completed.

Honda Spree and Elite 50 Forums

Wheel banding

Re: Wheel banding

Re: Wheel banding

Re: Wheel banding

Re: Wheel banding

Re: Wheel banding

Re: Wheel banding