Honda Spree and Elite 50 Forums

Hello, I've been lurking on this forum for a while and just wanted to let you know it's been extreemly helpful.

I have an Aero 50 that i'm having a difficult time starting when cold. Also, once it does start, it has a tendancy to die on me while idleing. I probably need to clean out the idle jet, but when I took off the bystarter, I noticed the o-ring was cracked and dry. Before I start taking the thing apart, I figure I better replace the o-ring first, just to make sure.

The question I have is: Does anyone know what size o-ring I need, and where I can get one?

Thanks

Take it (and the o-ring remnants) to virtually any hardware store that carries plumbing stuff, and check their o-ring selection.

yep, but make sure you have a clean air filter, and carb.