help with spree bore kit #2

[jamadi112233]

ok so heres my issue: i was running the bore kit with the 85 jet and i had a soft seize. started right back up no problems. So, i put in the 95 jet, way to rich. Now im running a 91 [#65 drill bit] I cannot get it to hit top rpm, it acts like its lean. When i run full throttle i cant get many rpm till i back off a bit. me first hint lean. Also when i let it breath with out the air box it hits even lower rpm. i can only hit 30 with the gears???? * im annoyed and any suggestions would be AMAZING.

[jamadi112233]

i ordered a 90 and an 85 so ill try messing with the needle something that i didn't do before

[jamadi112233]

i was able to find a 90 jet today. with the bore kit and the gears im only hitting 35? shouldnt i be getting a bit more MPH???

[bakaracer]

check the plug and see what it looks like.

[jamadi112233]

the plug looks good. i cant get more than 35 i went on a mile straight away and thats all shes got. any ideas? thats 35 by the spreedometer

[bakaracer]

what color is the plug? did you change the belt? did you clean out the exhaust?

[jamadi112233]

i have a brand new belt. the muffler is clean. my plug is #19 on this chart : http://www.dansmc.com/Spark_Plugs/Spark ... talog.html

[tazland001]

How fast was your spree going before you installed the gears and BBK?

Taz

[jamadi112233]

i was going right about 30 when i was stock. I should be getting the jets in the mail soon so i will see what i can get with a 90 like your running,

[tazland001]

how long did you have the 44mm kit in before you put the gear in. If you break in good you will hit better top end. If you break in fully you will not get as much. My spree goes faster. I can't ride it now but it hits 37-38 without much effort with the gears and BBK. When I go down hill it goes much faster. hehe. But I broke my cylinder in for 2 months.

Taz