Getting my elite 50 going! not getting gas?

ryanmcfinney · Post by **ryanmcfinney** » Sat Nov 19, 2005 9:07 am

My electric start isn't working, but that bystarter needle is always out. It should rest inside the brass tube?

KillinSpree · Post by **KillinSpree** » Sat Nov 19, 2005 9:33 am

Yes, if you try to mess with the electic choke than it might work.

maddog · Post by **maddog** » Tue Nov 22, 2005 5:07 pm

Take off the brake levers and check make sure the plungers aren't stuck, also check the wires at the starter and main harness.

ryanmcfinney · Post by **ryanmcfinney** » Thu Nov 24, 2005 2:39 pm

After carb cleaning part deux with special attention to the idle jet hole. It seems to be starting ok. I have to wait for it to warm up outside so I can get my rim and repaired tire on so I can evaluate if its truly working correctly....

Thanks again for all the help guys I couldn't have done it without ya!

Next project ( assuming everything is ok carb and engine wise )- getting the electic starter to work and fixing my front brake!

Yay!

Honda Spree and Elite 50 Forums

Getting my elite 50 going! not getting gas?

spree