roller weights?

darat · Post by **darat** » Tue Dec 27, 2005 12:15 pm

i now just have a stock eng on my elite. and i am running a 1000.rpm center spring and 9.5g weights but it seems a little slow off the line should i go with 8.5g

i need some input

maddog · Post by **maddog** » Wed Dec 28, 2005 12:24 am

Try putting a thin washer between the boss and the ramp and 8.5gr weights also sand the clutch bell with 60 grit, make sure the clutch pads are completely glazed, if all else fails go 1 step stiffer clutch springs.

lonelywanderer · Post by **lonelywanderer** » Mon Jan 02, 2006 8:30 pm

never hurts to try... what kind of clutch springs do you have?

hrnytrtlsgsxr · Post by **hrnytrtlsgsxr** » Mon Jan 02, 2006 8:34 pm

darat wrote:i now just have a stock eng on my elite. and i am running a 1000.rpm center spring and 9.5g weights but it seems a little slow off the line should i go with 8.5g

i need some input

is it reving when you are coming off the line. Or is there lull before hand.Then as it starts reving you start to take off. If the later is the problem then i would lighten the poller wights total by 1.5 at a time.

sulfuraciddd · Post by **sulfuraciddd** » Mon Jan 02, 2006 8:35 pm

lighten the weights and change that dam cluth springs

hrnytrtlsgsxr · Post by **hrnytrtlsgsxr** » Mon Jan 02, 2006 8:41 pm

sulfuraciddd wrote:lighten the weights and change that dam cluth springs

If it's bogging and you have to dethrottle and then throttle to get it going. Then change your center spring.

lonelywanderer · Post by **lonelywanderer** » Mon Jan 02, 2006 8:47 pm

all good tips....

Honda Spree and Elite 50 Forums

roller weights?

roller weights?

Re: roller weights?