my 85 spree had problems starting when it hasn't been run in a while I have to kick start it for at least 20 min and then it starts to fire. Once this thing gets going it runs perfect, and can start first crank when its been running for a while. Compression is 110+, good spark, and i can drain fuel out of the carb from the float screw after a crank or two.
Bystarter problem?
It's only been maybe 25 miles since I have rebuilt the carb and it has a brand new air filter.
Any insight is greatly appreciated guys!
85 spree cold start problems
Moderator: Moderator
-
- Goped
- Posts: 74
- Joined: Wed Dec 26, 2007 10:24 pm
- Location: Chicago
Re: 85 spree cold start problems
sounds like the bystarter. view this
http://hondaspree.net/wiki/index.php5?t ... at_It_Does
a the end of bystarter reassembly is a test procedure.
http://hondaspree.net/wiki/index.php5?t ... at_It_Does
a the end of bystarter reassembly is a test procedure.
taz 50mm bbk, 51g. rollers,1500 c spring
24mm arreche, #20 pilot, E2 needle clip on lower groove
arreche air filter
Naruku intake, reeds & block
v8 pipe
stock gears
trail tech temp & rpm gauges
24mm arreche, #20 pilot, E2 needle clip on lower groove
arreche air filter
Naruku intake, reeds & block
v8 pipe
stock gears
trail tech temp & rpm gauges
Re: 85 spree cold start problems
Sounds more like a low manifold vacuum or a shot petcock preventing a decent fuel supply while cranking.
Bear 45/70
'83 Aero 80 X 3
'84 Aero 80 X 3
'85 Aero 80
'84 Aero 125 X 2
'84 Aero 125
'84 Aero 125 X 2
'85 Aero 50
'85 Spree
'83 Aero 80 X 3
'84 Aero 80 X 3
'85 Aero 80
'84 Aero 125 X 2
'84 Aero 125
'84 Aero 125 X 2
'85 Aero 50
'85 Spree
- martynkim
- Board Supporter
- Posts: 2899
- Joined: Tue Jan 05, 2010 10:22 pm
- Location: Tacoma, Washington
Re: 85 spree cold start problems
starsnbars wrote:my 85 spree had problems starting when it hasn't been run in a while I have to kick start it for at least 20 min and then it starts to fire. Once this thing gets going it runs perfect, and can start first crank when its been running for a while. Compression is 110+, good spark, and i can drain fuel out of the carb from the float screw after a crank or two.
Bystarter problem?
It's only been maybe 25 miles since I have rebuilt the carb and it has a brand new air filter.
Any insight is greatly appreciated guys!
Instead of kicking for that long try priming your carb first. If it starts likely a fuel issue.
Need parts? Parting out Spree Aero and Elite!
What people share about buying from me http://www.hondaspree.net/phpBB3/viewto ... =1&t=15559
PM me with your needs Cheap Parts
What people share about buying from me http://www.hondaspree.net/phpBB3/viewto ... =1&t=15559
PM me with your needs Cheap Parts