want to build a trike

[motormike]

Thanx seanzee...manuals also contained here in WikiSpreedia..... ...Plus I have hard copy...Gyro S imported '85 &'86....

DSC00185.JPG (165.28 KiB) Viewed 2336 times

Majourlittle: Several would benefit from a schematic for Gyro rear wheel adapters. First dimension needed is the bolt pattern/diameter of Gyro S hubs....then the same for the wheels intended for replacing stocks. I can provide stock measurements, but no idea what wheels I would use to replace stocks....most likely an 8" with 4-lug on 4" dia.....( NOT buying wheels from Japan for $200 each)...spacing will also be at issue so adapter thickneess is critical to wheel choice. A basic schematic could be created and then revised for alternate wheel choices. Thanx for any drawings you can provide.........

[Majourlittle]

Lets do it then.

Need diameter of the bolt hole. need diameter of the center hole and need the inside-to-inside measurement of one bolt hole to the center hole.

PM me if you want to get this sorted.

[NC-redleg]

That is not my trike,sorry if that was the impression taken,was not my intent.I am working on a Lifan based trike and those are images that I have collected for ideas. The page that I posted has adapters to do that and there is a a guy on Ruckus .com that is working with different ones than stock. It is a simple matter to make a new plate for any existing rim with the proper spacing and offset.Russ

[swimmingfree]

look at what this guy did !!! and look at his other vid ..
swimmingfree

http://www.youtube.com/watch?feature=pl ... bsMWvhihAs

[e-Pirate]

:3