Honda Spree and Elite 50 Forums

Will the newer 2000 style fit on a 94 block? What needs to be done to make aftermarket gears fit this cover!

Yes, the cover will fit the block. The aftermarket gears need the same shims as with the '94 cover. You will need the big end axle with the '00 cover.

Yeah i got the bigger end axle. Is it normal for the clutch shaft to be able to slide right out

Also the primary gear is alot bigger than the older cover style

kingkamehameha wrote:Yeah i got the bigger end axle. Is it normal for the clutch shaft to be able to slide right out

kingkamehameha wrote:Also the primary gear is alot bigger than the older cover style

My experience is the primary shaft should not slide out without at least some light tapping with a mallet.
Should be same primary gear if it is stock af16, maybe it's a gear from af05 that you have? Just a suggestion. Good luck with it.

There are two different style gear covers one has a bearing on the cover side and the other just has a hole with a washer....which one do u have

kingkamehameha wrote:Yeah i got the bigger end axle. Is it normal for the clutch shaft to be able to slide right out

No, that should not happen. Measure the shaft and the bearing to see where the size if off. If you let it spin there, it will just lead to problems down the road.

kingkamehameha wrote:Also the primary gear is alot bigger than the older cover style

What is the tooth count?

Posted a pic

The '00 has looks like an aftermarket primary. Good money there. Looks like a 6.5 primary to me but it is hard to tell with the flash.

Impossible this cover came off a completely stock motor

For sure that is a tall ratio aftermarket primary.

Tooth count us 15x33. Ive never heard if those

kingkamehameha wrote:Tooth count us 15x33. Ive never heard if those

7.6