89 SB50P Elite 50...won't stop running
Moderator: Moderator
89 SB50P Elite 50...won't stop running
I have an 89 SB50P Elite 50 E scooter... Tonight I was driving the scooter to the store and it shut off fine with the red engine toggle switch at my first stop...10 minutes later, i went to walmart and it would not shut down with either the red toggle switch or with the key area.. what would cause this to happen? I had to shut it down my turning the idle adjust screw out till it shut down..
- swimmingfree
- CBR1000RR
- Posts: 3357
- Joined: Tue Jun 14, 2011 12:28 pm
- Location: mich.
Re: 89 SB50P Elite 50...won't stop running
running lean ..its to hot its call dieseling..
swimmingfree
swimmingfree
handicap (dyslexia)
looking for
se50 crank...
SpreJunk 87elite in a spree body
ruckus variator , 3.5 tire , 1500 drive face spring , a 64 bbk ,
8 gram rollers, stock carb , after market air filter and 105 jet
looking for
se50 crank...
SpreJunk 87elite in a spree body
ruckus variator , 3.5 tire , 1500 drive face spring , a 64 bbk ,
8 gram rollers, stock carb , after market air filter and 105 jet
Re: 89 SB50P Elite 50...won't stop running
i dont thats it...it wasnt sputtering it ran perfect..i could shut off both switches and give it gas and it purred like a kitten up and down the rmp rate.i have ridden further and harder than this in warmer weather and it shut off fine..
I think it electrical..
I think it electrical..
- swimmingfree
- CBR1000RR
- Posts: 3357
- Joined: Tue Jun 14, 2011 12:28 pm
- Location: mich.
Re: 89 SB50P Elite 50...won't stop running
im not sure if yours is the one im thinking of but ..one of this honda if you unplug the key switch it will run so you may be right .. but i wood do a plug crop to make sure im wrong.. i have been wrong before
swimmingfree
swimmingfree
handicap (dyslexia)
looking for
se50 crank...
SpreJunk 87elite in a spree body
ruckus variator , 3.5 tire , 1500 drive face spring , a 64 bbk ,
8 gram rollers, stock carb , after market air filter and 105 jet
looking for
se50 crank...
SpreJunk 87elite in a spree body
ruckus variator , 3.5 tire , 1500 drive face spring , a 64 bbk ,
8 gram rollers, stock carb , after market air filter and 105 jet
- Trafficjamz
- CBR1000RR
- Posts: 5353
- Joined: Tue Jul 14, 2009 7:53 pm
- Location: Eastlake, MI
- Contact:
Re: 89 SB50P Elite 50...won't stop running
most likely the kill (black/white) wire near the key switch came loose.bwhigham wrote:I have an 89 SB50P Elite 50 E scooter... Tonight I was driving the scooter to the store and it shut off fine with the red engine toggle switch at my first stop...10 minutes later, i went to walmart and it would not shut down with either the red toggle switch or with the key area.. what would cause this to happen? I had to shut it down my turning the idle adjust * out till it shut down..
new best 1/8th mile time 9.647 seconds @67.155 mph 310lbs total weight
Re: 89 SB50P Elite 50...won't stop running
I agree with traffic. Unless both switches failed at the same time, very unlikely at best, it has to be the connector on the black/white wire came loose.Trafficjamz wrote:most likely the kill (black/white) wire near the key switch came loose.bwhigham wrote:I have an 89 SB50P Elite 50 E scooter... Tonight I was driving the scooter to the store and it shut off fine with the red engine toggle switch at my first stop...10 minutes later, i went to walmart and it would not shut down with either the red toggle switch or with the key area.. what would cause this to happen? I had to shut it down my turning the idle adjust * out till it shut down..
Bear 45/70
'83 Aero 80 X 3
'84 Aero 80 X 3
'85 Aero 80
'84 Aero 125 X 2
'84 Aero 125
'84 Aero 125 X 2
'85 Aero 50
'85 Spree
'83 Aero 80 X 3
'84 Aero 80 X 3
'85 Aero 80
'84 Aero 125 X 2
'84 Aero 125
'84 Aero 125 X 2
'85 Aero 50
'85 Spree
Re: 89 SB50P Elite 50...won't stop running
Thank You all for your help...I will check the wiring on the switch now..
Re: 89 SB50P Elite 50...won't stop running
I tested both switches and they both checked out...I made sure that they were connected properly and they were....what else could it be?
Re: 89 SB50P Elite 50...won't stop running
Both switches are fine? what else could it be? where does the black and white wire go to? its connected at the switches?
Thanks anyone for your help...
Thanks anyone for your help...
Re: 89 SB50P Elite 50...won't stop running
Black/white wire goes to the CDI. Did you check for a ground on the other side of the switch. If you do not ground the black/white wire, the motor will never shut off.bwhigham wrote:Both switches are fine? what else could it be? where does the black and white wire go to? its connected at the switches?
Thanks anyone for your help...
Have you bothered to look at the wiring diagram in the service manual?
Bear 45/70
'83 Aero 80 X 3
'84 Aero 80 X 3
'85 Aero 80
'84 Aero 125 X 2
'84 Aero 125
'84 Aero 125 X 2
'85 Aero 50
'85 Spree
'83 Aero 80 X 3
'84 Aero 80 X 3
'85 Aero 80
'84 Aero 125 X 2
'84 Aero 125
'84 Aero 125 X 2
'85 Aero 50
'85 Spree
Re: 89 SB50P Elite 50...won't stop running
I can't follow the wiring diagram...its too complicated for me..
- swimmingfree
- CBR1000RR
- Posts: 3357
- Joined: Tue Jun 14, 2011 12:28 pm
- Location: mich.
Re: 89 SB50P Elite 50...won't stop running
i find printing it out helps..
swimmingfree
swimmingfree
handicap (dyslexia)
looking for
se50 crank...
SpreJunk 87elite in a spree body
ruckus variator , 3.5 tire , 1500 drive face spring , a 64 bbk ,
8 gram rollers, stock carb , after market air filter and 105 jet
looking for
se50 crank...
SpreJunk 87elite in a spree body
ruckus variator , 3.5 tire , 1500 drive face spring , a 64 bbk ,
8 gram rollers, stock carb , after market air filter and 105 jet
- Trafficjamz
- CBR1000RR
- Posts: 5353
- Joined: Tue Jul 14, 2009 7:53 pm
- Location: Eastlake, MI
- Contact:
Re: 89 SB50P Elite 50...won't stop running
bwhigham wrote:I can't follow the wiring diagram...its too complicated for me..
I appreciate your honesty
Do you have a digital volt meter?
There is a wire plug near the key switch that has four wires.
Find it and get back to me.
new best 1/8th mile time 9.647 seconds @67.155 mph 310lbs total weight
Re: 89 SB50P Elite 50...won't stop running
Is there a grounding block on the scooter? Where is it located? Its not shown on the equipment diagrams..I followed the wiring diagram...there seems to be a block, but Id like to know where it is so I don't have to take off all the body panels to find it..
Thank You,
Benjamin
Thank You,
Benjamin