DD built set up
Posted: Sat Aug 10, 2013 2:54 am
Hey, guys I need help with tuning my moped and getting right weights, jetting, gearings, springs, etc. Here's my set up.
- DD motor
- 72 polini corsa
- 44.4mm mini stroker
- pg long pipe
- cone air filter
- 6pcs of 7 grams weights
- 7 to 1 gearings
- 28 oko carb 135 main/50 pilot
- 1500 center spring (yellow)
- 1000 clutch spring (blue)
- 92 octone gas premix 3oz per gallon (around 40:1)
- I weight 130 pounds
It bogs at first when it's not warmed but it runs good after. It runs with temp around 300F-350F when cruising 50mph-60mph. It gets little faster than 70mph top speed but it feels like it could go faster and my temp goes around 400F when I full throttle so I stay away from doing that too much.
So guys, what can be done to make my dd better and faster? Any change in jettings, weights, gearings, springs, etc?
Some people say put 4oz per gallon (32:1) and that seems to much to me but does it run better than 3 oz per gallon?
- DD motor
- 72 polini corsa
- 44.4mm mini stroker
- pg long pipe
- cone air filter
- 6pcs of 7 grams weights
- 7 to 1 gearings
- 28 oko carb 135 main/50 pilot
- 1500 center spring (yellow)
- 1000 clutch spring (blue)
- 92 octone gas premix 3oz per gallon (around 40:1)
- I weight 130 pounds
It bogs at first when it's not warmed but it runs good after. It runs with temp around 300F-350F when cruising 50mph-60mph. It gets little faster than 70mph top speed but it feels like it could go faster and my temp goes around 400F when I full throttle so I stay away from doing that too much.
So guys, what can be done to make my dd better and faster? Any change in jettings, weights, gearings, springs, etc?
Some people say put 4oz per gallon (32:1) and that seems to much to me but does it run better than 3 oz per gallon?