oil leak question
Moderator: Moderator
- Rip_City_Spree
- CB900F
- Posts: 1379
- Joined: Sun Jun 13, 2010 7:47 pm
oil leak question
was replacing my exhaust gasket and saw there is oil gathering on the hole in the picture and not sure where it is coming coming from and thoughts guys?
- Attachments
-
- oil scooter.JPG (179.79 KiB) Viewed 3212 times
01 Elite SR
polini corsa
Polini 26mm Carb
Naraku intake
Naraku sport variator
Currently 5g rollers
zx trans
Arrow
red contra with yellow clutch springs.
RIP CITY
RIP NO MERCY KERSEY
polini corsa
Polini 26mm Carb
Naraku intake
Naraku sport variator
Currently 5g rollers
zx trans
Arrow
red contra with yellow clutch springs.
RIP CITY
RIP NO MERCY KERSEY
Re: oil leak question
Give the area a really good clean and scrub with brake cleaner and go for a ride. Might be as simple as some oil you spilled a while back. If not, then with the area clean you should be able to see where its coming from.
- Rip_City_Spree
- CB900F
- Posts: 1379
- Joined: Sun Jun 13, 2010 7:47 pm
Re: oil leak question
Yeah I cleaned guess the better question is what is that for?
01 Elite SR
polini corsa
Polini 26mm Carb
Naraku intake
Naraku sport variator
Currently 5g rollers
zx trans
Arrow
red contra with yellow clutch springs.
RIP CITY
RIP NO MERCY KERSEY
polini corsa
Polini 26mm Carb
Naraku intake
Naraku sport variator
Currently 5g rollers
zx trans
Arrow
red contra with yellow clutch springs.
RIP CITY
RIP NO MERCY KERSEY
- paulpauly7
- CB900F
- Posts: 1945
- Joined: Tue Feb 21, 2012 6:57 pm
- Location: nz
Re: oil leak question
is this a se50 motor ? If so the japanese models like the dj1r have a extra mount holding the exhaust .Pull your fan cover see if theres oil splatered around the inside if so it could be a crank seal
86 Nifty Fifty (spree)
ZX disk brake
Kitico 120kmh speedo
AF18 ZX ported
Polini corsa
Malossi crank
CTmani
24mmOKO
40pilot118main
Scorpion pipe
8.44 to 1
Michelin s1
71.3mph
92 yz125, 94 crm250
ZX disk brake
Kitico 120kmh speedo
AF18 ZX ported
Polini corsa
Malossi crank
CTmani
24mmOKO
40pilot118main
Scorpion pipe
8.44 to 1
Michelin s1
71.3mph
92 yz125, 94 crm250
- Dio89Elite
- Elite
- Posts: 701
- Joined: Wed Feb 01, 2012 3:55 pm
- Location: 50th state
Re: oil leak question
exhaust gasket leak would be my guess too
- Rip_City_Spree
- CB900F
- Posts: 1379
- Joined: Sun Jun 13, 2010 7:47 pm
Re: oil leak question
I did replace the exhaust gasket graphite9 thought it sounded like it had a small leak. Wasn't cracked but old will check to see if there is any more oil this weekend when I get my rim put on.
01 Elite SR
polini corsa
Polini 26mm Carb
Naraku intake
Naraku sport variator
Currently 5g rollers
zx trans
Arrow
red contra with yellow clutch springs.
RIP CITY
RIP NO MERCY KERSEY
polini corsa
Polini 26mm Carb
Naraku intake
Naraku sport variator
Currently 5g rollers
zx trans
Arrow
red contra with yellow clutch springs.
RIP CITY
RIP NO MERCY KERSEY
- Wheelman-111
- Moderator
- Posts: 11325
- Joined: Wed Oct 22, 2008 5:09 pm
- Location: Deepinnaharta, Texas
Re: oil leak question
Greetings:
Quoth Rip City:
Quoth Rip City:
It's hard to tell, and nobody knows LESS than I about Sprees, but isn't that the mounting hole for the cooling shroud? If so, there'd be a corresponding threaded hole in the crankcase unless it's not the shroud for that block.Yeah I cleaned guess the better question is what is that for?
Wheelman-111
Most of my money is spent on scooterparts. The rest is just wasted.
"ISO": '03 Vespa ET4 Malossi187 74MPH
Flash 9: 2001 Elite SR Contesta 72 ZX Tran, 9:1 Gears, Stock Airbox/Carb/Pipe 58.8 MPH
Punkin: 2010 Vespa/Malossi S78, 61MPH
Most of my money is spent on scooterparts. The rest is just wasted.
"ISO": '03 Vespa ET4 Malossi187 74MPH
Flash 9: 2001 Elite SR Contesta 72 ZX Tran, 9:1 Gears, Stock Airbox/Carb/Pipe 58.8 MPH
Punkin: 2010 Vespa/Malossi S78, 61MPH