Spree Controls with Ruckus ECU

Trying to get your Spree/Elite to run, or run better? Post your questions here.

Moderator: Moderator

Post Reply
_dafi
Noob
Noob
Posts: 5
Joined: Tue Jul 23, 2019 9:16 pm

Spree Controls with Ruckus ECU

Post by _dafi »

Hi all.

I'm doing a Ruckus GET engine swap on my 86' Spree and had a question about the starter switch wiring. I am using the original spree switch housing but running into an issue of the ignition coil not firing. The tail light will dim but there is no current coming from the ignition coil wires that connect to the coil itself. There is resistance on the ignition coil, so I am assuming everything is fine there.

The issue I may be running into is the correct way to wire the three wires from the spree switch housing and the 4 original wires that the Ruckus started switch had.

Image

I'm stumped as I don't know what to do from here.
_dafi
Noob
Noob
Posts: 5
Joined: Tue Jul 23, 2019 9:16 pm

Re: Spree Controls with Ruckus ECU

Post by _dafi »

Anyone?
User avatar
bonesv
Moderator
Moderator
Posts: 2128
Joined: Sun Jun 26, 2011 2:00 pm
Location: Florida

Re: Spree Controls with Ruckus ECU

Post by bonesv »

_dafi wrote: Thu Oct 10, 2019 10:44 amAnyone?
You may have to be patient. This is a 2-stroke forum. :roll:
Honda Elite SR
Honda Elite-Dio ZX

Dio ZX Headlight/Disc Brake Mod: http://hondaspree.net/phpBB3/viewtopic.php?t=30861
_dafi
Noob
Noob
Posts: 5
Joined: Tue Jul 23, 2019 9:16 pm

Re: Spree Controls with Ruckus ECU

Post by _dafi »

I understand thank you :)

I'm about to throw in the wrench. The ignition switch, when turned off, pops the fuse now. So I'm at wits end.
Post Reply